UL approved, the FE6800 is ideal for both FEMA 361 and FEMA 320 applications....
Search Results "Approved Testing Agency"
- Corbin Russwin Inc. FE6800 Fortified Multi-Point Latching System
- Guidance for Conducting Physical Functional Assessments for ADA Paratransit Eligibility
-
E202.5.2 Required Documentation
The responsible agency official shall document in writing the basis for determining that conformance to requirements in the 508 Standards constitute an undue burden on the agency, or would...
-
12113(a) In General
--It may be a defense to a charge of discrimination under this Act that an alleged application of qualification standards, tests, or selection criteria that screen out or tend to screen...
-
12113(a) In general
(a) In general It may be a defense to a charge of discrimination under this chapter that an alleged application of qualification standards, tests, or selection criteria that screen out...
-
§1630.15(b)(1) In general
It may be a defense to a charge of discrimination, as described in §1630.10, that an alleged application of qualification standards, tests, or selection criteria that screens out or tends...
-
§ 38.95(b)(9) Platform deflection
deflect more than 3 degrees (exclusive of vehicle roll) in any direction between its unloaded position and its position when loaded with 600 pounds applied through a 26 inch by 26 inch test...
-
§ 38.83(b)(9) Platform deflection
deflect more than 3 degrees (exclusive of vehicle roll) in any direction between its unloaded position and its position when loaded with 600 pounds applied through a 26 inch by 26 inch test...
-
§ 38.23(b)(9) Platform deflection
more than 3 degrees (exclusive of vehicle roll or pitch) in any direction between its unloaded position and its position when loaded with 600 pounds applied through a 26 inch by 26 inch test...
-
§ 38.125(b)(9) Platform deflection
not deflect more than 3 degrees (exclusive of car roll) in any direction between its unloaded position and its position when loaded with 600 pounds applied through a 26 inch by 26 inch test...
-
C.3.i. - Does Section 508 require contractors to manufacture EIT that meets the applicable Access Board’s technical provisions?
Agencies are responsible for ensuring that they undertake their acquisitions for EIT consistent with the requirements of Section 508, as implemented in the Access Board’s standards and the...
- American Standard Jocelyn 1-Handle Kitchen Faucet 9316.000
-
711.4.2 Membrane penetrations
Such penetrations shall not exceed an aggregate area of 100 square inches (64 500 mm2) in any 100 square feet (9.3 m2) of ceiling area in assemblies tested without penetrations....
-
Treatment of Data
Through further analysis, results of playground surface tests for firmness and stability were compared within surface categories and across surface categories to determine the mean, range...
-
Suggestion by Eldon Tipping
Tipping suggested that each ramp should be evaluated independently as a Random - Traffic Test Surface....
-
Acceptable SEWF Systems
Preliminary portable impact tests provided an indication of the cushioning performance of the stabilizing binder....
-
Appendix C Rotational Penetrometer Data Form
Beneficial Designs Serial num-ber: BDRP- Date of last calibration: Tire pressure set at 36 psi on (date): By: Date & Test...
-
Selection of Locations
The 11 test plots were installed in a previously undisturbed wetlands area where the maximum running slope of any of the sections was 7.6 percent....
-
APPENDIX A
The site plan will be labeled with locations 1‒9 to identify the critical test areas. One copy will be kept on file with NCA. ...
- University of Michigan Transportation Research Institute
-
§8.57(b) Noncompliance with §8.50
Department is not required to provide assistance during the pendency of the administrative proceeding under such paragraph (c), except where the assistance is due and payable under a contract approved...
-
C102.1 Incorporation by Reference
The Director of the Office of Federal Register has approved the standards for incorporation by reference in accordance with 5 U.S.C. 552(a) and 1 CFR Part 51....
-
E102.1 Incorporation by Reference
The Director of the Office of the Federal Register has approved the standards for incorporation by reference in accordance with 5 U.S.C. 552(a) and 1 CFR Part 51....
-
Department of Defense Memorandum: Adoption of the ABA and Section 504 of the Rehabilitation Act
DEPARTMENTS CHAIRMAN OF THE JOINT CHIEFS OF STAFF UNDER SECRETARIES OF DEFENSE ASSISTANT SECRETARIES OF DEFENSE GENERAL COUNSEL OF THE DEPARTMENT OF DEFENSE DIRECTOR, OPERATIONAL TEST...
