deflect more than 3 degrees (exclusive of vehicle roll) in any direction between its unloaded position and its position when loaded with 600 pounds applied through a 26 inch by 26 inch test...
Search Results "Approved Testing Agency"
Filters
Commonly Searched Documents
-
§ 38.83(b)(9) Platform deflection
-
§ 38.23(b)(9) Platform deflection
more than 3 degrees (exclusive of vehicle roll or pitch) in any direction between its unloaded position and its position when loaded with 600 pounds applied through a 26 inch by 26 inch test...
-
§ 38.125(b)(9) Platform deflection
not deflect more than 3 degrees (exclusive of car roll) in any direction between its unloaded position and its position when loaded with 600 pounds applied through a 26 inch by 26 inch test...
-
711.4.2 Membrane penetrations
Such penetrations shall not exceed an aggregate area of 100 square inches (64 500 mm2) in any 100 square feet (9.3 m2) of ceiling area in assemblies tested without penetrations....
-
Treatment of Data
Through further analysis, results of playground surface tests for firmness and stability were compared within surface categories and across surface categories to determine the mean, range...
-
Suggestion by Eldon Tipping
Tipping suggested that each ramp should be evaluated independently as a Random - Traffic Test Surface....
-
Acceptable SEWF Systems
Preliminary portable impact tests provided an indication of the cushioning performance of the stabilizing binder....
-
Appendix C Rotational Penetrometer Data Form
Beneficial Designs Serial num-ber: BDRP- Date of last calibration: Tire pressure set at 36 psi on (date): By: Date & Test...
-
University of Michigan Transportation Research Institute
University of Michigan Transportation Research Institute (UMTRI) has been involved in wheelchair-occupant safety research for more than thirty years and Biosciences researchers and test...
-
Selection of Locations
The 11 test plots were installed in a previously undisturbed wetlands area where the maximum running slope of any of the sections was 7.6 percent....
-
APPENDIX A
The site plan will be labeled with locations 1‒9 to identify the critical test areas. One copy will be kept on file with NCA. ...
-
E. Paperwork Reduction Act
Paperwork Reduction Act Under the Paperwork Reduction Act (PRA), agencies are prohibited from conducting or sponsoring a “collection of information” as defined by the PRA unless in advance...
-
E202.6.2 Required Documentation
The responsible agency official shall document in writing the basis for determining that conformance to requirements in the Revised 508 Standards constitute an undue burden on the agency...
-
Department of Defense Memorandum: Adoption of the ABA and Section 504 of the Rehabilitation Act
DEPARTMENTS CHAIRMAN OF THE JOINT CHIEFS OF STAFF UNDER SECRETARIES OF DEFENSE ASSISTANT SECRETARIES OF DEFENSE GENERAL COUNSEL OF THE DEPARTMENT OF DEFENSE DIRECTOR, OPERATIONAL TEST...
-
Automatic Curtain, Ltd. Remote Controlled Automatic Roller Shade System II
Opening position” and “Stop Position” are programmable • Controlled by a remote control • Very simply and easy installation • Safe and reliable 24V DC transformer w/GS, BS, CE or UL approval...
-
Gamco White Epoxy Painted Cover Hand Dryer - DR-5120
Motor shall be thermally-protected universal brush type motor operating at 13000 rpm and delivering 70 cfm air flow at a velocity of 140 MPH (12320 lfm), and cETLus approved....
-
Wheelchair Securement Systems
Commenters who supported this proposal included several vehicle manufacturers, three public transit agencies, an individual with a disability, and an accessibility consultant....
-
30. - 34.
The Department agrees to review and approve or disapprove any architectural and exhibition design plans submitted, in a timely manner, but no later than 30 business days after receipt of...
-
1630.15(b)(1)
It may be a defense to a charge of discrimination, as described in section 1630.10, that an alleged application of qualification standards, tests, or selection criteria that screens out...
-
§382.133(f)(2)
(2) Any applicable requirement for a manufacturer-affixed label to reflect that the device has been tested to meet requirements for medical portable electronic devices set by the FAA for...
-
711.2 Installation details
Insulation and coverings on or in the penetrating item shall not penetrate the assembly unless the specific material used has been tested as part of the assembly in accordance with this...
-
Basic Principles
If an educational background in architecture is a prerequisite to serve on a city board that reviews and approves building plans, a person with a disability who advocates for accessibility...
-
How are the ADA standards developed?
Under this process, agencies publish proposed language in the Federal Register, and then provide the public with the opportunity to provide input during a specified comment period....
-
Gamco Surface Mounted Hand Dryer - DR-5128
Motor shall be thermally-protected universal brush type motor operating at 13000 rpm and delivering 70 cfm air flow at a velocity of 140 MPH (12320 lfm), and cETLus approved....
