Characters on signs shall be selected from fonts that have a width-to-height ratio of between 3:5 (60 percent) and 1:1 (100 percent) measured by the width of the uppercase letter "O" and...
Search Results "Measuring Technique"
Filters
Commonly Searched Documents
-
1117B.5.3
-
Transit Stops (R308.1) (Section-by-Section Analysis)
Transit Stops (R308.1) (Section-by-Section Analysis) Boarding and alighting areas at sidewalk or street level transit stops must be 2.4 meters (8 feet) minimum measured perpendicular...
-
Literature Review
The second topic was to explore ways to measure, design, and monitor the quality of pathway surfaces for WC users. Therefore two separate searches were conducted....
-
Accessible Pathway & Corridor: Minimum Clear Width Required for 180-degree Turn
Findings from the Anthropometry of Wheeled Mobility Study indicate that a width of at least 130 cm (51 in.) was required for 50% of the manual wheelchair users measured in this study to...
-
Accessible Pathway & Corridor: Minimum Clear Width Required for 180-degree Turn Around Barrier
Findings from the Anthropometry of Wheeled Mobility Study indicate that a uniform width of at least 89.5 cm (35 in.) was required for 50% of the manual and power wheelchair users measured...
-
1136A.1 Receptacle heights
Electrical receptacle outlets on branch circuits of 30 amperes or less and communication system receptacles shall be located no more than 48 inches (1219 mm) measured from the top of the...
-
Bobrick Recessed Toilet Tissue Dispensers B-697
Double roll model measures 12 5⁄16" W x 6 1⁄8" H (315 x 155mm). Mounting: clamps for securing to stud walls or countertop aprons....
-
Bobrick Recessed Toilet Tissue Dispensers B-6977
Double roll model measures 12 5⁄16" W x 6 1⁄8" H (315 x 155mm). Mounting: clamps for securing to stud walls or countertop aprons....
-
American Specialties Folding Shower Seat 8208-R
Seat measures 33" (840 mm) wide and projects 22 7/8" (580 mm) from wall....
-
Trimco 1102 Series Cast Pull
The 1102 Pulls are ADA compliant and measure 5-1/2″ CTC. They are available in most architectural finishes to match just about any design....
-
Doorbell Factory Square Stainless Steel Doorbell
Solid 3/16" thick Stainless Steel Plate Comes with non-lighted push button and mounting screws Measures 3" W x 3" H square Usually ships in 1-3 business days...
-
Bobrick Recessed Toilet Tissue Dispenser B-6697
Single-roll model measure 6 1⁄8" W x 6 1⁄8" H (155 x 155mm)....
-
Privacy: ADA Standard Section 707.4
., a covered entity does not have to take measures that would result in a fundamental alteration of its program or would cause undue burdens, provide adequate protection to operators of...
-
1015.2 Where required
Guards shall be located along open-sided walking surfaces, including mezzanines, equipment platforms, aisles, stairs, ramps and landings that are located more than 30 inches (762 mm) measured...
-
M301.2.1 Adjustability
Transfer surfaces shall be adjustable in height measured from the floor to the top of the uncompressed transfer surface and shall provide the following: A....
-
M302.2.1 Adjustability
Transfer surfaces shall be adjustable in height measured from the floor to the top of the uncompressed transfer surface and shall provide the following: A....
-
Floor Designations
The proposed rule specified that tactile floor designations at the hoistway be 60 inches above the floor, measured from the baseline of the characters (407.2.4)....
-
Accessible Pool Stairs
ADAAG provisions for stairs include the requirement that all steps have uniform riser heights and uniform tread widths of not less than 11 inches, measured from riser to riser....
-
§104.44(c) Course examinations
student's achievement in the course, rather than reflecting the student's impaired sensory, manual, or speaking skills (except where such skills are the factors that the test purports to measure...
-
7(2)(b)(vii)
If the shower stall is the only bathing facility provided in the covered dwelling unit, or on the accessible level of a covered multistory unit, and measures a nominal 36 x 36, the shower...
-
608.2.3 Alternate Roll-In Type Shower Compartments
Alternate roll-in type shower compartments shall be 36 inches (915 mm) wide and 60 inches (1525 mm) deep minimum clear inside dimensions measured at center points of opposing sides....
-
2 Method
The two main dependent measures were: Whether the detectable warnings could be seen from distances between 2.44 m (8ft) and 7.92 m (26 ft)....
-
903.4 Back Support
Back support shall be 2 1/2 inches (64 mm) maximum from the rear edge of the seat measured horizontally. ...
-
11B-604.7.1 Dispensers
Toilet paper dispensers shall comply with Section 11B-309.4 and shall be 7 inches (178 mm) minimum and 9 inches (229 mm) maximum in front of the water closet measured to the centerline of...
