Where the diagnostic equipment is used in a reclined position, head and back support shall be provided. Where the incline of the back support can be modified while in use, head and...
Search Results "Adjusted Construction Cost"
-
M301.3.3 Head and Back Support
-
A. Section 504
programs or activities because a recipient’s facilities are inaccessible to or unusable by individuals with disabilities.4 Among other things, the regulation requires that the design, construction...
-
Adjustable gap protocol
Adjustable gap protocol: From initial setup, just the horizontal distance between the WMD and platform was incrementally increased by placing plywood blocks of 3.5” (8.9cm) width between...
-
Are the elements of path of travel and accessible routes substantively the same (such as slope, vertical clearance, width of path of travel, etc.)?
Compliance is required to the maximum extent feasible without exceeding 20 percent of the cost of the work directly associated with the installation of EVCS (see Section 11B-202.4 Exception...
-
Sec.36.401(d)(1)
(1) For purposes of this paragraph (d) --
-
§ 36.401(d)(1)
(1) For purposes of this paragraph (d) –
-
Utility Sinks
A utility sink is deeper than a standard restroom basin or kitchen sink and can be used to clean large pots or equipment. Usually, utility sinks are provided only in highly developed...
- Midmark 630 HUMANFORM™ Procedures Table
- Simple Pump Company ADA 100 Simple Water Pump
- Sears Brands, LLC Craftsman Digital Torpedo Level
-
11B-201.1 Scope, 11B-201.2 Application based on building or facility use, 11B-202.2 Additions, 11B-202.3 Alterations
Each addition to an existing building or facility shall comply with the requirements for new construction and shall comply with Section 11B-202.4. 11B-202.3 Alterations....
-
Overview
March 15, 2012, is also the compliance date for using the 2010 Standards for new construction, alterations, program accessibility, and barrier removal....
-
5.3.1 Permitted Obstructions to Transfer Sides for M301 and M302
Rationale for the recommendation Transfer supports provide handholds on adjustable medical equipment to facilitate transfers onto and off the equipment....
-
M301.2.3.1 End Transfer Surface
End transfer surfaces shall be 28 inches (710 mm) wide minimum and 17 inches (430 mm) long minimum. EXCEPTION: Transfer surfaces for imaging equipment with bores shall be...
-
M301.2.3.2 Side Transfer Surface
Side transfer surfaces shall be 28 inches (710 mm) wide minimum and 28 inches (710 mm) long minimum. EXCEPTION: Transfer surfaces for imaging equipment with bores shall be...
-
M301.2.4 Unobstructed Transfer
Each transfer surface shall provide two unobstructed sides for patient transfer. EXCEPTIONS: 1. Obstructions no more than 3 inches (75 mm) deep shall be permitted to extend beyond...
-
M301.4 Lift Compatibility
Diagnostic equipment shall be usable with portable patient lifts and, when in use with such lifts, shall comply with M301.4.1 or M301.4.2. EXCEPTION: Where fixed overhead patient...
-
M301.2.4 Unobstructed Transfer (Section-by-Section Analysis)
In the MDE NPRM the Access Board proposed that each transfer side provide unobstructed access to the transfer surface, with an exception to permit temporary obstructions as long as...
-
Master Bath
Unglazed ceramic mosaic tile for slip resistance Sink adaptable to a seated position Reinforcement for ceiling lift from the bed to the bathtub and...
-
M301.4 Lift Compatibility
Diagnostic equipment shall be usable with a patient lift and shall comply with M301.4.1 or M301.4.2.
-
M301.2.3 Transfer Sides
The transfer surface shall be located to provide options to transfer from a mobility device onto one short side (depth) and one long side (width) of the surface. Each transfer side...
- Magnuson Group RETTO Outdoor Waste Receptacle
-
Exam Tables and Chairs
Individuals with mobility disabilities often need to use an adjustable-height table which, when positioned at a low height, allows them to transfer from a wheelchair....
-
COSTS TO LOWER MINIMUM TABLE HEIGHT
COSTS TO LOWER MINIMUM TABLE HEIGHT To be useful for its intended purpose, examination tables and chairs must maintain a high height of at least 32 inches, so that the health care provider...