Where on-board fare collection devices are used, a horizontal passenger assist shall be located between boarding passengers and the fare collection device and shall prevent passengers from...
Search Results "Horizontal Dispersion"
Filters
Commonly Searched Documents
-
§ 38.155(a)
-
11B-809.10.5.2 Reinforcement for grab bars
Grab bar backing shall be installed horizontally to permit the installation of a 48-inch (1219 mm) grab bar with each end 6 inches (152 mm) maximum from the end walls of the bathtub....
-
1015.2 Where required
equipment platforms, aisles, stairs, ramps and landings that are located more than 30 inches (762 mm) measured vertically to the floor or grade below at any point within 36 inches (914 mm) horizontally...
-
Revised and New Standards for Buildings and Facilities
places of lodging include requirements for the number of accessible guest rooms providing mobility and communication features and there is also a requirement that these accessible rooms be dispersed...
-
Different "Types"
"Rocking" is an example of horizontal movement that can be backwards, forwards, sideways or even circular in nature. ...
-
Eunice Noell-Waggoner, IES, LC. Value, Contrast and Reflections
Polished Horizontal Surfaces (slide 5) Disability Glare can distort pathways. Reflected glare can result from windows, skylights and electric down lights....
-
1134A.5, Item 2
Grab bar backing shall be installed horizontally to permit the installation of a 48-inch (1219 mm) grab bar with each end a maximum of 6 inches (152.4 mm) from the end walls of the bathtub...
-
1134A.5, Item 2
Grab bar backing shall be installed horizontally to permit the installation of a 48-inch (1219 mm) grab bar with each end a maximum of 6 inches (152.4 mm) from the end walls of the bathtub...
-
§ 38.29(b)
Where on-board fare collection devices are used on vehicles in excess of 22 feet in length, a horizontal passenger assist shall be located across the front of the vehicle and shall prevent...
-
1010.1.4 Floor elevation
Landings shall be level except for exterior landings, which are permitted to have a slope not to exceed 0.25 unit vertical in 12 units horizontal (2-percent slope)....
-
Diaper Deck Infant Changing Table
Horizontal design only allows the baby to roll towards the wall and the parent greatly reducing your liability. ...
-
d. Unobstructed Transfer
In the preamble to the MDE NPRM the Access Board noted that it was considering permitting equipment parts to extend a maximum of three inches horizontally beyond the edge of the transfer...
-
General
The 1991 Standards require areas of rescue assistance or horizontal exits in facilities with levels above or below the level of exit discharge....
-
810.5.3 Platform and Vehicle Floor Coordination
The height and position of a platform must be coordinated with the floor of the vehicles it serves to minimize the vertical and horizontal gaps, in accordance with the ADA Accessibility...
-
Benches
Benches must be strong enough to withstand a vertical or horizontal force of 250 pounds applied at any point on the seat, fastener, mounting device, or supporting structure....
-
810.5.3 Platform and Vehicle Floor Coordination
The height and position of a platform must be coordinated with the floor of the vehicles it serves to minimize the vertical and horizontal gaps, in accordance with the ADA Accessibility...
-
Front grab bar protocol
The horizontal distance between the center of the grab bar and the mid-center, front edge of the platform was 13.5”. ...
-
Sight Lines
Sight Lines Both the horizontal and vertical viewing angles must be considered in the design of assembly areas....
-
Gurney Accessible Bathroom
toilet in the shower for use as a seat or to use with a shower wheelchair for clean up after bowel/bladder program Wall mounted “P” trap for the sink (to clear the knee space) with horizontal...
-
§ 38.175(a)
The design of cars shall be coordinated with the boarding platform design such that the horizontal gap between a car door at rest and the platform shall be no greater than 3 inches and the...
-
Section 36.406(f)(3)
The use of temporary platforms has the effect of neutralizing dispersion and other seating requirements (e.g., line of sight) for wheelchair spaces and companion seats. Cf....
-
Wheelchair Spaces/Companion Seats
The requisite number of wheelchair spaces and companion seats required in the tiered boxes are to be dispersed among at least twenty percent (20%) of the tiered boxes....
-
Sections 5 Through 9 (Preamble, Section-by-Section Analysis)
Accessible counters shall be dispersed throughout the facility. At counters such as bank teller windows or ticketing counters, alternative methods of compliance are permitted....
-
Sections 5 Through 9 (Section-By-Section Analysis and Response to Comments)
Accessible counters shall be dispersed throughout the facility. At counters such as bank teller windows or ticketing counters, alternative methods of compliance are permitted....
