Penetrations of membranes that are part of a fire-resistance-rated horizontal assembly shall comply with Section 711.4.1.1 or 711.4.1.2....
Search Results "Horizontal Dispersion"
-
711.4.2 Membrane penetrations
-
1003.2.12.2 Opening limitations
In occupancies in Group I-3, F, H or S, balusters, horizontal intermediate rails or other construction shall not permit a sphere with a diameter of 21 inches (533 mm) to pass through any...
-
4.8.5* HANDRAILS
If a ramp run has a rise greater than 6 in (250 mm) or a horizontal projection greater than 72 in (1830 mm), then it shall have handrails on both sides....
-
§ 38.77(b)
Where on-board fare collection devices are used, a horizontal passenger assist shall be located between boarding passengers and the fare collection device and shall prevent passengers from...
-
§ 38.155(a)
Where on-board fare collection devices are used, a horizontal passenger assist shall be located between boarding passengers and the fare collection device and shall prevent passengers from...
-
11B-809.10.5.2 Reinforcement for grab bars
Grab bar backing shall be installed horizontally to permit the installation of a 48-inch (1219 mm) grab bar with each end 6 inches (152 mm) maximum from the end walls of the bathtub....
-
1015.2 Where required
equipment platforms, aisles, stairs, ramps and landings that are located more than 30 inches (762 mm) measured vertically to the floor or grade below at any point within 36 inches (914 mm) horizontally...
-
1134A.8 Lavatories, vanities, mirrors and towel fixtures
Vanities and lavatories shall be installed with the centerline of the fixture a minimum of 18 inches (457 mm) horizontally from an adjoining wall or fixture to allow for forward approach...
-
Diaper Deck Infant Changing Table
Horizontal design only allows the baby to roll towards the wall and the parent greatly reducing your liability. ...
-
Revised and New Standards for Buildings and Facilities
places of lodging include requirements for the number of accessible guest rooms providing mobility and communication features and there is also a requirement that these accessible rooms be dispersed...
-
Different "Types"
"Rocking" is an example of horizontal movement that can be backwards, forwards, sideways or even circular in nature. ...
-
Eunice Noell-Waggoner, IES, LC. Value, Contrast and Reflections
Polished Horizontal Surfaces (slide 5) Disability Glare can distort pathways. Reflected glare can result from windows, skylights and electric down lights....
-
1134A.5, Item 2
Grab bar backing shall be installed horizontally to permit the installation of a 48-inch (1219 mm) grab bar with each end a maximum of 6 inches (152.4 mm) from the end walls of the bathtub...
-
1134A.5, Item 2
Grab bar backing shall be installed horizontally to permit the installation of a 48-inch (1219 mm) grab bar with each end a maximum of 6 inches (152.4 mm) from the end walls of the bathtub...
-
§ 38.29(b)
Where on-board fare collection devices are used on vehicles in excess of 22 feet in length, a horizontal passenger assist shall be located across the front of the vehicle and shall prevent...
-
1010.1.4 Floor elevation
Landings shall be level except for exterior landings, which are permitted to have a slope not to exceed 0.25 unit vertical in 12 units horizontal (2-percent slope)....
-
1010.1.4 Floor elevation
Landings shall be level except for exterior landings, which are permitted to have a slope not to exceed 0.25 unit vertical in 12 units horizontal (2-percent slope)....
-
Behavioral Safety Products #DH410 Cylindrical Ligature Resistant Lever Handle
The lever handle's stationary position is horizontal, but rotates freely up or down (bidirectional) to allow slippage of any ligature device in an attempt to tie or wrap over the top or...
-
American Specialties 9012 Surface Mounted Baby Changing Station
under the unloaded bed tray, after installation, of 27" to 27-3/8" [686 to 695] and the rim of the changing table will be 30-13/16" to 31-3/16" [783 to 792] above finished floor when in horizontal...
-
Endorphin 325 Functional Wall Pulley
Adjustable, rotating arms & swivel handles allow for a wide range of stabilizing exercises that improve balance and core strength Rotating arms adjust from ground level to 7 feet, 90º horizontally...
-
810.5.3 Platform and Vehicle Floor Coordination
The height and position of a platform must be coordinated with the floor of the vehicles it serves to minimize the vertical and horizontal gaps, in accordance with the ADA Accessibility...
-
Benches
Benches must be strong enough to withstand a vertical or horizontal force of 250 pounds applied at any point on the seat, fastener, mounting device, or supporting structure....
-
810.5.3 Platform and Vehicle Floor Coordination
The height and position of a platform must be coordinated with the floor of the vehicles it serves to minimize the vertical and horizontal gaps, in accordance with the ADA Accessibility...
-
Front grab bar protocol
The horizontal distance between the center of the grab bar and the mid-center, front edge of the platform was 13.5”. ...
