.063" Engineer Grade reflective aluminum to improve sign visibility at night Extend the life and performance of the sign by upgrading to Seton UltraTuff™ overlaminate Sign measures...
Search Results "Tape Measure"
-
Seton Parking Signs - Blue Reserved Parking with ISA
-
Inclusion Solutions Blue Parking Stop
Steel installation anchors included Measures 72"L x 4"H x 6"W Weighs 30 lbs....
-
Public Postsecondary Schools
, rather than reflecting the applicant's impaired sensory, manual, or speaking skills (except where those skills are the factors that the test purports to measure); (ii) admissions tests...
-
1016.5 Obstacles
Obstacles on outdoor recreation access routes, passing spaces, and resting intervals shall not exceed 1/2 inch (13 mm) in height measured vertically to the highest point....
-
703.3.1 Dimensions and Capitalization
Table 703.3.1 Braille Dimensions Measurement Range Minimum in Inches Maximum in Inches Dot base diameter 0.059 (1.5 mm) to 0.063 (1.6 mm)...
-
1016.5 Obstacles
Obstacles on outdoor recreation access routes, passing spaces, and resting intervals shall not exceed 1/2 inch (13 mm) in height measured vertically to the highest point....
-
11B-809.8.3 Door maneuvering clearance.
At the dwelling unit side of the primary entry doors, secondary exterior doors, and required exit doors maneuvering clearances shall be 44 inches (1118 mm) minimum in length measured...
-
11B-705.1.2.2.2.1 One entrance/exit point
Where the turning space has one entrance/exit point other than the sloped ramp segments, detectable warnings shall be 36 inches (914 mm) deep, as measured perpendicular to the curb, and...
-
11B-705.1.1.2 Dome spacing
detectable warning surface shall have a center-to-center spacing of 2.3 inches (58 mm) minimum and 2.4 inches (61 mm) maximum, and a base-to-base spacing of 0.65 inch (16.5 mm) minimum, measured...
-
R410.9 Character Spacing
Character spacing shall be measured between the two closest points of adjacent characters, excluding word spaces....
-
§ 36.304(d)(3) Reduced scoping for public accommodations
For measures taken to comply with the barrier removal requirements of this section, existing facilities shall comply with the applicable requirements for alterations in § 36.402 and §§ 36.404...
-
Can handrails overlap ramp landings?
Along runs and landings, the minimum clear width must be measured between the leading edge of handrails....
-
§ 38.31(b)
(b) Other stepwells and doorways, including doorways in which lifts or ramps are installed, shall have, at all times, at least 2 foot-candles of illumination measured on the step tread,...
-
703.5.8 Character Spacing
Character spacing shall be measured between the two closest points of adjacent characters, excluding word spaces....
-
General [4.5.1]
No standard or method of measurement exists for these characteristics except for slip-resistance....
-
11B-604.8.1.1 Size
Wheelchair accessible compartments shall be 60 inches (1524 mm) wide minimum measured perpendicular to the side wall, and 56 inches (1422 mm) deep minimum for wall hung water closets and...
-
Inclusion Solutions Offset Door Hinge
The hinge measures 2" x 3-1/2" with a decorative, long lasting brass finish. (2" wide to wrap the trim)....
-
2. Accommodation in testing
that tests be given to people who have impaired sensory, speaking or manual skills in a format and manner that does not require use of the impaired skill, unless the test is designed to measure...
-
§382.55(a)
In addition, passengers at foreign airports, including those with disabilities, may be subject to security screening measures required by law of the country in which the airport is located...
-
Issue 5: Can a new chapter be written with a structure for PBS P100 that is performance based and does not disaggregate lighting design by professional disciplines (i.e., integrates subject matter in Chapters 2, 3, 5, and 6)?
Comments by [Participants]: Criteria should be based on measurable psychosocial and psychophysiological metrics (i.e., parameters and values)....
-
1(2)(b)(ii)
vehicular or pedestrian arrival points within 50 feet of the planned entrance, the unusual characteristics result in a difference in finished grade elevation exceeding 30 inches and 10 percent measured...
-
1132A.3, Item 5
A pair of doors, manual or automatic, must have at least one leaf which provides a clear width of not less than 32 inches (813 mm), measured with the door positioned at an angle of 90 degrees...
-
1134A.6, Item 1.3
1.3 Other shower stall configurations shall measure at least 36 inches deep by 60 inches wide (914 mm by 1524 mm) with an entrance opening of at least 36 inches (914 mm) when a wall is...
-
§35.130(f)
(f) A public entity may not place a surcharge on a particular individual with a disability or any group of individuals with disabilities to cover the costs of measures, such as the provision...
