Urinals shall be 13½ inches (345 mm) deep minimum measured from the outer face of the urinal rim to the back of the fixture. Figure 605.2 Height and Depth of Urinals...
Search Results "Back Support"
Filters
Commonly Searched Documents
-
605.2 Height and Depth
-
605.2 Height and Depth
Urinals shall be 13½ inches (345 mm) deep minimum measured from the outer face of the urinal rim to the back of the fixture....
-
7.4.11.1 Clear Space
Trailhead signs shall be located centered at the back of a 30- by 48-inch (760- by 1,220-millimeter) minimum clear floor or ground space....
-
§ 38.113(d)(3) Exception
Where platform set-backs do not allow the horizontal gap or vertical alignment specified in paragraph (d) (1) or (2), platform or portable lifts complying with §38.125(b) of this part, or...
-
Turning Space: ADA Standard Section 809.2.2
However, the overlap of turning space must be limited to one segment of the T-turn so that back-up maneuvering is not restricted....
-
Service Animal:
With respect to emotional support animals, although carriers may require documentation to verify that an animal is an emotional support animal, such documentation is not required under the...
-
General: ADA Standard Section 306.1
Section 306.1 of the ADA Standards covers information in the current ADA Standards for knee and toe clearance.
-
Pilot Rock Bench B110C with Full-length Grab Bar
The full-length grab bar across the back of the bench enhances access and transfer to or from this bench....
-
§ 38.83(c)(1) Design load
Ramps or bridge plates 30 inches or longer shall support a load of 600 pounds, placed at the centroid of the ramp or bridge plate distributed over an area of 26 inches, with a safety factor...
-
11B-219.5 Permanent and portable systems
An adequate number of electrical outlets or other supplementary wiring necessary to support a portable assistive-listening system shall be provided....
-
2.2.2 Structural Anthropometry (i.e. Body and WhMD Dimensions)
Left and right arm support surface planes (defined by four corner points each) Informs the 3-D digital model of WhMD....
-
7. What remedies address violations of the ADA’s integration mandate in the context of disability employment systems?
The Department has entered into settlement agreements that require states to expand the services and supports available in integrated employment settings....
-
608.3.3 Alternate Roll-In Type Shower Compartments
In alternate roll-in type shower compartments, grab bars shall be provided on the back wall and the side wall farthest from the compartment entry....
-
3.3 Lexington Woodhill Movies 10, 425 Codell Drive Lexington, Kentucky
3.3 Lexington Woodhill Movies 10 425 Codell Drive Lexington, Kentucky - In Auditoria 3 and 10, the four (4) wheelchair spaces shall be relocated one row farther back in the auditorium...
-
Microsoft Word implementation
For more guidance, see Agency specific information at the back of this document....
-
R305.2 Placement
Where the back of curb edge is tooled to provide a radius, the border dimension should be measured from the end of the radius....
-
Is color contrast required for stair nosings?
The ASME A17.1 code requires escalator steps to be demarcated by yellow lines 2” wide maximum along the back and sides....
-
11B-608.3.3 Alternate roll-in type shower compartments
In alternate roll-in type shower compartments, grab bars shall be provided on the back wall and the side wall farthest from the compartment entry....
-
§ 38.107(a)(3)
long shall be mounted behind the water closet, and a horizontal grab bar at least 40 inches long shall be mounted on at least one side wall, with one end not more than 12 inches from the back...
-
§ 38.123(a)(3)
long shall be mounted behind the water closet, and a horizontal grab bar at least 40 inches long shall be mounted on at least one side wall, with one end not more than 12 inches from the back...
-
C201.1 Scope
Manufacturers shall also conform to the requirements in the Revised 255 Guidelines for support documentation and services, including electronic documents and Web-based product support....
-
§ 38.125(c)(1) Design load
Ramps or bridge plates 30 inches or longer shall support a load of 600 pounds, placed at the centroid of the ramp or bridge plate distributed over an area of 26 inches by 26 inches, with...
-
§ 38.95(c)(1) Design load
Ramps or bridge plates 30 inches or longer shall support a load of 600 pounds, placed at the centroid of the ramp or bridge plate distributed over an area of 26 inches by 26 inches, with...
-
C. Collaboration with Other Entities
Services such as scattered-site supported housing, Assertive Community Treatment (ACT), crisis services, intensive case management, respite, personal care services, behavior support, nursing...
