centerlines of the seat, and the height from the floor to the highest point of the transfer surface: The depth is measured between the perineal cutout and the hinge point at the back...
Search Results "Back Support"
Commonly Searched Documents
-
MEASUREMENT TECHNIQUE
-
R304.2.1 Turning Space
Where the turning space is constrained at the back-of-sidewalk, the turning space shall be 1.2 m (4.0 ft) minimum by 1.5 m (5.0 ft) minimum....
-
Approach, Enter, and Exit
Access Board, “approach, enter, and exit” means that people using wheelchairs must be able to enter and back out of the space....
-
4.13.12* Automatic Doors and Power-Assisted Doors
Such doors shall not open to back check faster than 3 seconds and shall require no more than 15 lbf (66.6N) to stop door movement....
-
Islands [4.7.11]
If there is no level space between ramps, wheelchairs can "bottom out" or "high center" while proceeding down one ramp while the back wheels are coming up the other slope....
-
Controls [§404.3.5]
Recommendation: Placing controls in locations that preclude backing-up will facilitate usability....
-
Van Space: Wider Parking Space
space and regular accessible space share an aisle, it is advisable to have the access aisle serve the van space on the passenger side (as is required where van spaces are angled) since backing...
-
11B-610.2 Bathtub seats
Permanent seats at the head end of the bathtub shall be 15 inches (381 mm) deep minimum and shall extend from the back wall to or beyond the outer edge of the bathtub....
-
Step 1 - Start Implementation
A well-publicized public declaration of support or adoption of a formal policy statement can set a positive tone that facilitates staff involvement and promotes support and cooperation....
-
The Americans with Disabilities Act
It embodies a philosophy and constitutes a declaration in support of human possibility and capability. . . ....
-
Chapter 3: Publicizing the ADA: Advocacy and the Government Response
Publicizing the ADA: Advocacy and the Government Response Gallaudet University erupted on March 1, 1988, as an estimated 1,500 alumni, students, faculty, and community supporters...
-
DSA IR 16-12: GRAB BAR DESIGN AND CONNECTIONS: 2019 CBC
The wall capacity shall be established in the same manner. 2.3 As an alternate to Section 2.2 above for grab bars spanning 36” or less between supports, a connection using a back-up...
-
M304 Diagnostic Equipment Used by Patients in Standing Position
M304.2 and M304.3 would require a slip resistant standing surface and standing supports to accommodate patients with mobility disabilities who ambulate, patients who have limited stamina...
-
§382.117(e)(2)
(2) The passenger needs the emotional support or psychiatric service animal as an accommodation for air travel and/or for activity at the passenger's destination;...
-
4.34.6.4(3)
(3) Counter thickness and supporting structure shall be 2 in (50 mm) maximum over the required clear area....
-
4.34.6.5(6)
(6) Counter thickness and supporting structure shall be 2 in (50 mm) maximum over the required clear space....
-
68.10(3) Building
(3) Building--Any structure located in the State of Texas that is used and intended for supporting or sheltering any use or occupancy....
- ZoomText 10.1 for Windows 8 Introductory Video
-
5.8.2.4 Unobstructed Floor Space
The unobstructed floor space in front of the base support should be a minimum of 17 inches deep....
-
504.1 General
Where an application is an authoring tool, the application shall conform to 504 to the extent that information required for accessibility is supported by the destination format....
-
Islands: ADA Standard Section 406.7
Section 406.7 covers the current ADA Standards for islands.
-
M101.2 Application (Section-by-Section Analysis)
In the NPRM the Access Board proposed that the MDE Standards would be applied to diagnostic equipment based on the patient position the equipment is designed to support....
-
4.Information, documentation, and training
Such information and documentation includes user guides, installation guides for end-user installable devices, and product support communications, regarding both the product in general and...