(1) the building or facility has been brought into compliance; or...
Search Results "Fire-Building Surface"
Filters
Commonly Searched Documents
-
Sec. 469.059(a)(1)
-
§ 36.401(d)(1)(ii)(A)
(A) A building housing five or more sales or rental establishments; or...
-
106.5.26 Element
An architectural or mechanical component of a building, facility, space, or site....
-
4.1.6(1) GENERAL
Alterations to existing buildings or facilities shall comply with the following:...
-
1009.4.2 Area of refuge
Areas of refuge are not required in buildings and facilities equipped throughout with an automatic sprinkler system installed in accordance with Section 903.3.1.1 or 903.3.1....
-
PUBLIC USE
Public use may be provided at a building or facility that is privately or publicly owned....
-
Appendix 4 – References
Adelaide South Australia, Public Buildings Department. Bails, J.H. (1983). ...
-
Covered Multifamily Dwellings
The Fair Housing Act and its regulations clearly define "covered multifamily dwellings" as buildings consisting of four or more dwelling units, if such buildings have one or more elevators...
-
The Commenters
These commenters included: the Southern Building Code Congress International (SBCCI); the U.S....
-
7. Path of Travel Requirements and Adjusted Construction Cost
alterations incidental to the primary scope of installing a PV system are included as part of the project, the adjusted construction cost for purposes of complying with the 2013 California Building...
-
For People with Disabilities, Which Circulation Paths Are Usable, Available, and Closest?
These plans should be given to visitors who are blind or have low vision when they enter the building so they can find the exits in an emergency....
-
SHOPPING CENTER (OR SHOPPING MALL)
For the purposes of this section, “shopping center” or “shopping mall” includes a covered mall building. Advisory Definition of SHOPPING CENTER (or SHOPPING MALL). ...
-
2. Mirrors
Mirrors: If provided, mirrors need to be mounted with the bottom edge of the reflecting surface no higher than 40 inches above the floor....
-
705.1 General
Detectable warnings shall consist of a surface of truncated domes and shall comply with 705. Figure 705.1 Size and Spacing of Truncated Domes...
-
Boat Launch Ramp
A sloped surface designed for launching and retrieving trailered boats and other water craft to and from a body of water....
-
Confirm that the vibrotactile indications work
Confirm that the vibrotactile indications work The tactile arrow or vibrating surface should vibrate rapidly only during the walk interval for the street....
-
5.4.3.1 Positioning Support Height for Imaging Equipment
Positioning supports should be positioned 3 to 6 inches above the transfer surface....
-
R305.2.6 Boarding Platforms
At boarding platforms for buses and rail vehicles, detectable warning surfaces shall be placed at the boarding edge of the platform....
-
e-i
Is the curb ramp surface at least 36 inches wide, excluding flared sides? [ADA Standards § 4.7.3] Yes No...
-
11B-502.6.4 Marking
Each accessible car and van space shall have surface identification complying with either Section 11B-502.6.4.1 or 11B-502.6.4.2....
-
RAMP
A walking surface that has a running slope steeper than one unit vertical in 20 units horizontal (5-percent slope)....
-
11B-502.6.4 Marking
Each accessible car and van space shall have surface identification complying with either Section 11B-502.6.4.1 or 11B-502.6.4.2. ...
-
11B-502.6.4 Marking
Each accessible car and van space shall have surface identification complying with either Section 11B-502.6.4.1 or 11B-502.6.4.2....
-
RAMP
A walking surface that has a running slope steeper than one unit vertical in 20 units horizontal (5-percent slope)....