Also, consider providing a minimum clear width of 60 inches if the ORAR is a boardwalk or otherwise not at the same level as the adjoining ground surface or if the edge is bordered by timbers...
Search Results "End Transfer Surface"
-
Passing Spaces [1016.4]
-
Appendix C Rotational Penetrometer Data Form
Appendix C National Center on Accessibility - National Trails Surface Study Rotational Penetrometer Data Form Trails Information Trail Name: ...
-
6. Dissemination Activities
Development of Surface Roughness Standards for Pathways used by Wheelchairs. Presented at Transportation Research Board Annual Meeting. Washington D.C....
- Symmons Temptrol II (2000 Series) Tub/Shower Mixing Valve 15-2
- Symmons® Canterbury Two Handle Widespread Lavatory Faucet SLW-4512-1.5
- Symmons® Allura Two Handle Widespread Lavatory Faucet SLW-4712-1.5
-
1009.3.1 Sloped Entries
EXCEPTION: Where sloped entries are provided, the surfaces shall not be required to be slip resistant....
-
1009.3.1 Sloped Entries
EXCEPTION: Where sloped entries are provided, the surfaces shall not be required to be slip resistant....
-
T503.4 Steps at Other Doorways
The walking surface on steps serving all other non-rail vehicle doorways shall be lighted at all times with 2 foot-candles (22 lux) minimum of illumination....
-
903.5 Height
The top of the bench seat surface shall be 17 inches (430 mm) minimum and 19 inches (485 mm) maximum above the finish floor or ground....
-
5.3.3.1 Height
The total height of the toilet seat on the riser for a pit toilet shall be between 17 inches (430 mm) and 19 inches (485 mm) above the floor or ground surface....
-
1011.2 Clear Ground Space
This section requires a clear ground space to be provided at outdoor constructed features and includes specific provisions for the size and location (1011.2.1), surface (1011.2.2), slope...
-
4.34.6.5(8)
(8) There shall be no sharp or abrasive surfaces under sinks. Hot water and drain pipes under sinks shall be insulated or otherwise covered. Figure 51 Kitchen Sink...
-
5.3.3.1 Height
The total height of the toilet seat on the riser for a pit toilet shall be between 17 inches (430 mm) and 19 inches (485 mm) above the floor or ground surface....
-
Garage Parking
At sites that also include surface lots, a garage is treated as a separate parking facility for scoping purposes....
-
1133A.7.1 Plumbing protection
There shall be no sharp or abrasive surfaces under kitchen sinks....
-
1133A.7.1 Plumbing protection
There shall be no sharp or abrasive surfaces under kitchen sinks....
-
III. Summary of Comments
Survey,3 including equipment characteristics that affect patients ability to access and use medical equipment, such as: dimensions of the equipment (e.g. height, width, length,) contact surfaces...
-
Alterations
Section 226.1, exempts sales and service counters from the technical requirements of 902 (dining surfaces and work surfaces)....
- Tour-Mate
-
Literature Review
The first review of the literature focused on the effects of surface roughness on the health and safety of WC riders....
-
Evaluating the Accessibility of a Meeting Site
access does not relieve facility owners of their continuing obligations under the ADA to remove barriers and provide increased access to people with disabilities after the meeting has ended...
-
Interim Segway® Personal Transporter Policy
To that end, GSA's Public Buildings Service is issuing this interim policy to permit individuals with a mobility impairment to use these devices in Federal buildings under GSA’s jurisdiction...
-
Grab Bar Cross Sections
The Board has clarified that the space between grab bars and projecting objects below and at the ends shall be 1 ½ inches minimum, consistent with criteria for water closets, tubs, and showers...