Specifically, this section would establish requirements for position (i.e., vertical reference plane), forward reach, and side reach....
Search Results "Side Transfer Surface"
-
407.12 Reach Height (Section-by-Section Analysis)
- TOTO® MS854114EL Commercial Eco UltraMax One-Piece Toilet ADA Height
-
Construction and Maintenance Practices
Stagger speed humps to block only one lane at a time or limit them to the center of the road, leaving 32 inches (815 millimeters) of clear passage at each side....
-
11B-705.1.1.2 Dome spacing
Truncated domes in a detectable warning surface shall have a center-to-center spacing of 2.3 inches (58 mm) minimum and 2.4 inches (61 mm) maximum, and a base-to-base spacing of 0.65 inch...
-
11B-705.1.1.2 Dome spacing
Truncated domes in a detectable warning surface shall have a center-to-center spacing of 2.3 inches (58 mm) minimum and 2.4 inches (61 mm) maximum, and a base-to-base spacing of 0.65 inch...
-
1133B.2.4.2
Regardless of the occupant load, there shall be a floor or landing on each side of a door. 1133B.2.4.2 Maneuvering clearances at doors. ...
-
Notes
AA For adjustable height chairs with footplates, as the height of the chair seat (transfer surface) moves up and down, the footplate moves up and down at the same time (i.e., with a fixed...
-
GRAB BAR
A grab bar may also provide support for a user transferring from a wheelchair onto a bench, seat or plumbing fixture. ◼...
-
12162(a)(3)(A)(i)(II)
(II) to fold and store wheelchairs (to accommodate individuals who wish to transfer to coach seats) equal to not less than one-half of the number of single-level rail passenger coaches in...
- AJW Architectural Products U1511EA Series Automatic ADA Compliant Hand Dryer, Universal Voltage - Surface Mounted
- AJW Architectural Products U103 33 oz. Single Cartridge ABS Liquid Soap Dispenser - Surface Mounted
-
11B-809.10.6.2 Slope
The floor surfaces shall be of Carborundum, grit-faced tile or of material providing equivalent slip resistance....
-
11B-809.10.6.2 Slope
The floor surfaces shall be of Carborundum, grit-faced tile or of material providing equivalent slip resistance....
-
Alterations
Where play components are altered and the ground surface is not, the ground surface does not have to comply with the ASTM F 1951-99 standard for accessible surfaces unless the cost of providing...
-
IV. ACCESSIBLE MEDICAL EQUIPMENT
from a wheelchair or other mobility device without slipping, and shall have a protective padded surface (unless such a surface is inconsistent with the table’s intended use)....
-
608.2.3 Alternate Roll-In Type Shower Compartments
Alternate roll-in type shower compartments shall be 36 inches (915 mm) wide and 60 inches (1525 mm) deep minimum clear inside dimensions measured at center points of opposing sides....
-
11B-502.6.4.1
The centerline of the International Symbol of Accessibility shall be a maximum of 6 inches (152 mm) from the centerline of the parking space, its sides parallel to the length of the parking...
-
11B-502.6.4.1
The centerline of the International Symbol of Accessibility shall be a maximum of 6 inches (152 mm) from the centerline of the parking space, its sides parallel to the length of the parking...
- Willoughby Industries 2235 Series AquaDeck Lavatory Deck
-
What is slip resistance?
In fact, a truly non-slip surface could not be negotiated....
-
5. Conclusions
This study found that surface characteristics, more specifically surface roughness, can have a large impact on the WBVs that WC users are exposed to....
-
11B-502.6 Identification
Signs shall be 60 inches (1524 mm) minimum above the finish floor or ground surface measured to the bottom of the sign. [2010 ADA Standards] 502.6 Identification....
-
11B-502.6 Identification
Signs shall be 60 inches (1524 mm) minimum above the finish floor or ground surface measured to the bottom of the sign. [2010 ADA Standards] 502.6 Identification....
- Willoughby Industries 2250 AquaDeck Lavatory Deck Radiused Front