A portion of the counter surface that is 36 inches (914 mm) long minimum and 34 inches (864 mm) high maximum above the finish floor shall be provided....
Search Results "Feasibility (Technical, Infeasible, Structural, Maximum Extent)"
-
11B-904.4.1 Parallel approach
-
11B-604.4 Seats
The seat height of a water closet above the finish floor shall be 17 inches (432 mm) minimum and 19 inches (483 mm) maximum measured to the top of the seat....
-
11B-903.4 Back support
Back support shall be 48 inches (1219 mm) long minimum and shall extend from a point 2 inches (51 mm) maximum above the seat surface to a point 18 inches (457 mm) minimum above the seat...
-
M301.4.2 Clearance Around Base (Section-by-Section Analysis)
The width of the base permitted within this clearance would be 26 inches maximum at the edge of the examination surface and was permitted to increase at a rate of 1 inch in width for every...
-
A) Accessible Parking
Access aisle of at least 60-inch width must be level (1:50 maximum slope in all directions), be the same length as the adjacent parking space(s) it serves and must connect to an accessible...
-
M305 Supports (Section-by-Section Analysis)
M305 in the final rule provides the technical requirements for transfer supports, standing supports, leg supports, and head and back supports....
-
1. What is considered an "accessible" play component?
An "accessible" play component is one that is located on an accessible route and meets the technical provisions of Section 1008.4. Remember, the standards are only minimums....
-
F.2. - What should be included in a nonavailability determination?
FAR 39.203(c)(2) requires that the documentation must include a description of market research performed and identification of the applicable technical provisions that cannot be met with...
-
9.1.1 General
All public use and common use areas are required to be designed and constructed to comply with section 4 (Accessible Elements and Spaces: Scope and Technical Requirements)....
-
E101.1 Purpose
These 508 Standards, which consist of 508 Chapters 1 and 2 (Appendix A), along with Chapters 3 through 6 (Appendix C), contain scoping and technical requirements for information and communication...
-
ACKNOWLEDGMENTS
Ann Do is the Contracting Officer's Technical Representative....
-
FAQ: Does the content go through a Quality Control process?
including images, products from external websites, links to external websites, and videos, goes through extensive quality control (QC) processes, including review by at least one of ETA’s technical...
-
[A] APPROVED
material, type of construction, fixture or appliance as the result of investigations and tests conducted by the agency, or by reason of accepted principles or tests by national authorities or technical...
-
APPROVED
material, type of construction, fixture or appliance as the result of investigations and tests conducted by the agency, or by reason of accepted principles or tests by national authorities or technical...
-
Landscape Forms Inc. Arcata Collection Benches
With robust structure and visual sweep, Arcata meets the measure of expansive outdoor spaces offering a unique combination of classic and contemporary forms....
-
407.12 Reach Height (Section-by-Section Analysis)
We are proposing to use the term “stationary” to address concerns that the word “freestanding” implies an independent supporting structure that may not always be in place, such as with a...
-
Audible WALK indications
As with pushbutton locator tones, the 2003 MUTCD requires that the volume of the audible WALK indication be carefully adjusted to be heard a minimum of 1.8 m (6 feet) and a maximum of 3.7...
-
Alteration
but are not limited to, remodeling, renovation, rehabilitation, reconstruction, historic restoration, resurfacing of circulation paths or vehicular ways, changes or rearrangement of the structural...
-
24.1 Q. What types of grab bars should the reinforcement be designed to accommodate and what types may be used if the builder elects to install grab bars in some units at the time of construction?
The Guidelines do not prescribe the type of product for grab bars, or the structural strength for grab bars....
-
§35.150(d)(1)
(1) In the event that structural changes to facilities will be undertaken to achieve program accessibility, a public entity that employs 50 or more persons shall develop, within six months...
-
Alteration
Alterations include, but are not limited to, remodeling, renovation, rehabilitation, reconstruction, historic restoration, changes or rearrangement of the structural parts or elements, and...
-
5.3.6 Entrance
Exception: Where bedrock, perma-frost or other environmental conditions prohibit a level entry or the toilet design (such as a composting toilet) necessitates a raised toilet structure,...
-
Alteration of a recreation site, building, or facility
not limited to, remodeling, renovation, rehabilitation, reconstruction, historic restoration, change in surface of circulation paths or vehicular ways, changes or rearrangement of the structural...
-
5.3.6 Entrance
Exception: Where bedrock, perma-frost or other environmental conditions prohibit a level entry or the toilet design (such as a composting toilet) necessitates a raised toilet structure,...
