Hand operated flush controls shall comply with Sections 11B-309.2 and 11B-309.4 and shall be installed 36 inches (914 mm) maximum above the finish floor....
Search Results "Maximum Reach Depth"
Filters
Commonly Searched Documents
-
11B-604.9.5 Flush controls
-
5.3.3.2 Location Where Walls Provided
The centerline of the seat shall be 16 inches (405 mm) minimum to 18 inches (455 mm) maximum from the side wall or partition. ...
-
4.7.5 Sides of Curb Ramps
If a curb ramp is located where pedestrians must walk across the ramp, or where it is not protected by handrails or guardrails, it shall have flared sides; the maximum slope of the flare...
-
Scoping [4.1.3(5)]
access to: performing areas in assembly occupancies wheelchair seating locations in assembly occupancies incidental space or rooms not open to the public with a maximum...
-
4.1.6(4)(d)
(i) Where existing elements prohibit strict compliance with the clearance requirements of 4.13.5, a projection of 5/8 in (16 mm) maximum will be permitted for the latch side door stop....
-
5.3.3.2 Location Where Walls Provided
The centerline of the seat shall be 16 inches (405 mm) minimum to 18 inches (455 mm) maximum from the side wall or partition....
-
Is color contrast required for stair nosings?
The ASME A17.1 code requires escalator steps to be demarcated by yellow lines 2” wide maximum along the back and sides....
-
DRIVE-UP ELECTRIC VEHICLE CHARGING STATION
An electric vehicle charging station in which use is limited to 30 minutes maximum and is provided at a location where the electric vehicle approaches in the forward direction, stops in...
-
§ 38.113(a)(2)
(2) Doorways at ends of cars connecting two adjacent cars, to the maximum extent practicable in accordance with regulations issued under the Federal Railroad Safety Act of 1970 (49 CFR parts...
-
11B-608.3.3 Alternate roll-in type shower compartments
Grab bars shall be installed 6 inches (152 mm) maximum from adjacent walls....
-
§ 38.23(b)(10) Platform movement
The maximum platform horizontal and vertical acceleration when occupied shall be 0.3g....
-
§ 38.125(b)(10) Platform movement
The maximum platform horizontal and vertical acceleration when occupied shall be 0.3g....
-
§ 38.83(b)(10) Platform movement
The maximum platform horizontal and vertical acceleration when occupied shall be 0.3g....
-
§ 38.95(b)(10) Platform movement
The maximum platform horizontal and vertical acceleration when occupied shall be 0.3g....
-
DRIVE-UP ELECTRIC VEHICLE CHARGING STATION
An electric vehicle charging station in which use is limited to 30 minutes maximum and is provided at a location where the electric vehicle approaches in the forward direction, stops in...
-
11B-604.9.5 Flush controls
Hand operated flush controls shall comply with Sections 11B-309.2 and 11B-309.4 and shall be installed 36 inches (914 mm) maximum above the finish floor....
-
ENSURING LANGUAGE ACCESS AND EFFECTIVE COMMUNICATION DURING RESPONSE AND RECOVERY: A CHECKLIST FOR EMERGENCY RESPONDERS
As an emergency responder, it is critical for you to be prepared to effectively reach all members of the community during emergency response and recovery efforts....
-
Midmark 647 Barrier-Free® Power Podiatry Procedures Chair
Patient Load Rating: 450 lb. (204 kg) Base Height: Minimum 19" (48.3 cm) Maximum 40" (101.6 cm) Foot Section Height: With foot section retracted 15.5" to 54" (39.4...
-
Toilet Buildings and Pit Toilets
The depth of the clear space is measured from the back of the riser and extends in front of the riser (figure 110)....
-
11B-405.2 Slope
Table 405.2 Maximum Ramp Slope and Rise for Existing Sites, Buildings, and Facilities Slope1 Maximum Rise Steeper than 1:10...
-
Grab Bar Cross Sections
Non-circular cross sections were to have maximum cross section dimensions of 2 inches, a perimeter dimension between 4 and 4‒11/16 inches, and edges with a c inch minimum radius....
-
5. Are there any tax credits or deductions to help me comply?
This credit can cover 50% of the eligible access expenditures in a year up to $10,250 (maximum credit of $5000)....
-
12147(a) General rule
section 12132 of this title and section 794 of title 29, for a public entity to fail to make such alterations (or to ensure that the alterations are made) in such a manner that, to the maximum...
