The Wading Pool Ramp will have a slope ratio that is technically feasible, readily achievable, and is based on the ADA maximum extent feasibility requirements for any wading pool. ...
Search Results "Maximum Reach Depth"
Filters
Commonly Searched Documents
-
AquaTrek2 ADA Wading Pool Ramp
-
Typical examples of reasonable modifications are:
Instructing staff that if a customer who has lost the use of his or her arms asks them to reach into a shirt or jacket pocket to retrieve the wallet or credit card needed to pay the bill...
-
O. Public Notification
Announcement of this policy of non-discrimination may be made, for example, in local newspapers, recipient publications and/or other media that reach the general public, program beneficiaries...
-
§35.150(a)(3)
designee after considering all resources available for use in the funding and operation of the service, program, or activity, and must be accompanied by a written statement of the reasons for reaching...
-
2.1.2.1 Summary of IEC 118‒4 (1981) Standards
Allowing for the 12 dB peaks occurring in speech signals, peak field strength may reach 400 mA/meter. The frequency response shall be 100 Hz - 5 kHz +/- 3 dB....
-
III-7.5185 Automated teller machines
It may be possible to show that meeting only one of the reach ranges with respect to a particular ATM, as installed, provides equivalent facilitation in compliance with ADAAG....
-
Laying the Foundation: Disability Policy & Activism, 1968-1988
The fact that the ADA did reach President Bush’s desk and was signed into law is a tribute to the groundwork that had been laid in the previous two decades....
-
Tips for Attendees
Communicate early and often with the event hosts; complete registration forms with as much detail as possible, and reach out to the hosts a few weeks before the event to ask if they have...
-
§ 35.150(a)(3)
designee after considering all resources available for use in the funding and operation of the service, program, or activity, and must be accompanied by a written statement of the reasons for reaching...
-
Examinations and Courses. (Section-by-Section Analysis)
Because section 309 of the ADA 42 U.S.C. 12189, reaches ‘‘[a]ny person that offers examinations or courses related to applications, licensing, certification, or credentialing for secondary...
-
608.3.3 Alternate Roll-In Type Shower Compartments
Grab bars shall be installed 6 inches (150 mm) maximum from adjacent walls. Figure 608.3.3 Grab Bars for Alternate Roll-In Type Showers...
-
Cross Slope
Comments indicated that specifications for cross slope (1:48 maximum) are not referenced in the curb ramp section. Response....
-
§382.133(a)
disability to use in the passenger cabin during air transportation an electronic assistive device specified in paragraph (c) of this section on all aircraft originally designed to have a maximum...
-
Width and Length
Width and Length Transfer walls must be a minimum of 12 inches wide to a maximum of 16 inches wide....
-
703.2.5 Character Height
Character height measured vertically from the baseline of the character shall be 5/8 inch (16 mm) minimum and 2 inches (51 mm) maximum based on the height of the uppercase letter “I”....
-
239.2 Minimum Number
If a course is designed with the minimum 50 percent accessible holes, designers or operators are encouraged to select holes which provide for an equivalent experience to the maximum extent...
-
F239.2 Minimum Number
If a course is designed with the minimum 50 percent accessible holes, designers or operators are encouraged to select holes which provide for an equivalent experience to the maximum extent...
-
11B-604.9.5 Flush controls
Hand operated flush controls shall comply with Sections 11B-309.2 and 11B-309.4 and shall be installed 36 inches (914 mm) maximum above the finish floor....
-
5.3.3.2 Location Where Walls Provided
The centerline of the seat shall be 16 inches (405 mm) minimum to 18 inches (455 mm) maximum from the side wall or partition. ...
-
4.7.5 Sides of Curb Ramps
If a curb ramp is located where pedestrians must walk across the ramp, or where it is not protected by handrails or guardrails, it shall have flared sides; the maximum slope of the flare...
-
Scoping [4.1.3(5)]
access to: performing areas in assembly occupancies wheelchair seating locations in assembly occupancies incidental space or rooms not open to the public with a maximum...
-
4.1.6(4)(d)
(i) Where existing elements prohibit strict compliance with the clearance requirements of 4.13.5, a projection of 5/8 in (16 mm) maximum will be permitted for the latch side door stop....
-
5.3.3.2 Location Where Walls Provided
The centerline of the seat shall be 16 inches (405 mm) minimum to 18 inches (455 mm) maximum from the side wall or partition....
-
Is color contrast required for stair nosings?
The ASME A17.1 code requires escalator steps to be demarcated by yellow lines 2” wide maximum along the back and sides....