Addressed in Technical Criteria Types Of Equipment To Which Technical Criteria Applies Seated in a wheelchair (M303) Wheelchair space, including orientation, width, depth...
Search Results "Maximum Reach Depth"
Filters
Commonly Searched Documents
-
Medical Diagnostic Equipment Accessibility Standards Sub-Committee Recommendations Weight Scales
-
Introduction
In Phase I, processing techniques and material properties were evaluated in small benchtop and full-depth laboratory tests (Laufenberg and others 2003)....
-
407.4.1 Car Dimensions
EXCEPTION: Existing elevator car configurations that provide a clear floor area of 16 square feet (1.5 m2) minimum and also provide an inside clear depth 54 inches (1370 mm) minimum and...
-
Study Method
Rather, the results are the in-depth reflections of the eight participants on their museum and park experiences....
-
¼ Inch Minus Limestone
Eventually, the surface developed an erosion ditch measuring approximately 16 feet and at a depth of approximately 3 inches....
-
ALIGNMENT OF 19-INCH RECOMMENDATION WITH ACCESS BOARD PROPOSED RULEMAKING
ALIGNMENT OF 19-INCH RECOMMENDATION WITH ACCESS BOARD PROPOSED RULEMAKING The subcommittee’s recommendation of a lower adjustable height of 19 inches maximum is consistent with the U.S...
-
GE Profile™ Series 30" Slide-In Double Oven Electric Convection Range PS950EFES
Content Weights and Dimensions Approximate Shipping Weight 259 lb Cabinet Width 30 in Cooktop Width 31 1/4 in Depth...
-
11B-1003.3.2 Boarding pier clearances
Every 10 feet (3048 mm) maximum of linear pier edge shall contain at least one continuous clear opening 60 inches (1524 mm) wide minimum. Exceptions: 1. ...
-
1003.3.2 Boarding Pier Clearances
Every 10 feet (3050 mm) maximum of linear pier edge shall contain at least one continuous clear opening 60 inches (1525 mm) wide minimum. EXCEPTIONS: 1....
-
Protocol C Heights Obtained
For the maximum height transfers HERL's percentile heights were slightly higher for the 25th and 75th percentiles than the NDVWSC heights....
-
1003.3.2 Boarding Pier Clearances
Every 10 feet (3050 mm) maximum of linear pier edge shall contain at least one continuous clear opening 60 inches (1525 mm) wide minimum. EXCEPTIONS: 1....
-
11B-610.3 Shower compartment seats
The top of the seat shall be 17 inches (432 mm) minimum and 19 inches (483 mm) maximum above the bathroom finish floor....
-
104 Conventions
Section 104.1 of the 2010 Standards notes that dimensions not stated as a “maximum” or “minimum” are absolute....
-
Audible Hall Signals
The proposed rule included a maximum frequency (1,500 Hz) for audible signals....
-
11B-610.3 Shower compartment seats
The top of the seat shall be 17 inches (432 mm) minimum and 19 inches (483 mm) maximum above the bathroom finish floor....
-
11B-608.6 Shower spray unit and water
Shower spray units shall deliver water that is 120°F (49°C) maximum....
-
11B-608.6 Shower spray unit and water
Shower spray units shall deliver water that is 120°F (49°C) maximum....
-
608.6 Shower Spray Unit and Water
Shower spray units shall deliver water that is 120°F (49°C) maximum....
-
Tax Credits and Deductions
This credit can cover 50% of the eligible access expenditures in a year up to $10,250 (maximum credit of $5000)....
-
608.6 Shower Spray Unit and Water
Shower spray units shall deliver water that is 120°F (49°C) maximum....
-
Restrooms Main Lobby
The force required to push or pull open the interior hinged doors to the restroom vestibule door is 10 lbf, which exceeds the maximum allowable door opening force of 5 lbf....
-
Parallel Curb Ramps (R304.3) (Section-by-Section Analysis)
A minimum running slope of 5 percent and a maximum running slope of 8.3 percent are specified for parallel curb ramps, and the ramp length is limited to 4.5 meters (15 feet)....
-
24. Q: Are there tax credits or deductions available to help offset the costs associated with complying with the ADA?
This credit can cover 50% of the eligible access expenditures in a year up to $10,250 (maximum credit of $5,000)....
-
604.9.5 Flush Controls
Hand operated flush controls shall comply with 309.2 and 309.4 and shall be installed 36 inches (915 mm) maximum above the finish floor....
