.-- Each Federal agency that has responsibility under paragraph (2) for implementing this Act may render technical assistance to individuals and institutions that have rights or duties under...
Search Results "Feasibility (Technical, Infeasible, Structural, Maximum Extent)"
-
12206(c)(1) Rendering assistance
-
601.1 Scope (Section-by-Section Analysis)
601.1 Scope (Section-by-Section Analysis) This section proposes that the technical requirements for support documentation and services in this chapter be applied where either (a) required...
-
Gates and Barriers on Trails
Refer to the FSTAG for the technical provisions for gates and barriers....
-
11B-249.1.2
ETA Editor's Note The scoping and technical requirements for adult changing facilities are new in CBC 2019....
-
Number of Accessible Entrances
increasing scoping for public entrances (206.4.1 removing a requirement for accessible ground floor entrances (206.4.3 in the proposed rule) revision of provision for parking structure...
-
Stowage of Wheelchairs and Mobility Aids
One commenter asserted that the requirement to carry power wheelchairs in the baggage compartment was inconsistent with ICAO technical standards and IATA dangerous goods rules....
-
Pilot Rock APTX Snow Load/Extreme Load Full Size Pedestal Utility Table
In order to achieve this weight rating, these steel frame tables must be equipped with our V-Type expanded steel or H-Type perforated steel table structures. ...
-
ADA Information Sources
ADA Information Sources Department of Justice ADA Information Line The ADA Information Line is available during weekdays to provide technical assistance on the ADA Standards for Accessible...
-
National Technology Transfer and Advancement Act of 1995
The National Technology Transfer and Advancement Act of 1995 (NTTAA) directs that all federal agencies and departments shall use technical standards that are developed or adopted by voluntary...
-
E.4. - What are examples of issues an agency may wish to consider when drafting a solicitation to acquire EIT?
Among other things, agencies should consider drafting solicitations in a way that they may accept a product or service that partially meets the applicable technical provisions if no product...
-
National Technology Transfer and Advancement Act of 1995
The National Technology Transfer and Advancement Act of 1995 (NTTAA) directs that all federal agencies and departments use technical standards that are developed or adopted by voluntary...
-
National Technology Transfer and Advancement Act of 1995
The National Technology Transfer and Advancement Act of 1995 (NTTAA) directs that, as a general matter, all Federal agencies and departments shall use technical standards that are developed...
-
T304 Operable Parts
The technical requirements for operable parts in the 2016 Non-Rail Vehicle Guidelines remain the same as in the proposed rule; however, they have been slightly reorganized so that all requirements...
-
National Technology Transfer and Advancement Act of 1995
The National Technology Transfer and Advancement Act of 1995 (NTTAA) directs that as a general matter, all Federal agencies and departments shall use technical standards that are developed...
-
ASTM
It defines the use zone, which is the ground area beneath and immediately adjacent to a play structure or play equipment designed for unrestricted circulation around the equipment and on...
-
ASTM
It defines the use zone, which is the ground area beneath and immediately adjacent to a play structure or play equipment designed for unrestricted circulation around the equipment and on...
-
607.4.1.1 Back Wall
Two grab bars shall be installed on the back wall, one located in accordance with 609.4 and the other located 8 inches (205 mm) minimum and 10 inches (255 mm) maximum above the rim of the...
-
11B-607.4.2.1 Back wall
Two grab bars shall be installed on the back wall, one located in accordance with Section 11B-609.4 and the other located 8 inches (203 mm) minimum and 10 inches (254 mm) maximum above the...
-
11B-1002.4.4.3 Permitted protrusions in wheelchair spaces
Objects are permitted to protrude a distance of 6 inches (152 mm) maximum along the front of the wheelchair space, where located 9 inches (229 mm) minimum and 27 inches (686 mm) maximum...
-
11B-1002.4.4.3 Permitted protrusions in wheelchair spaces
Objects are permitted to protrude a distance of 6 inches (152 mm) maximum along the front of the wheelchair space, where located 9 inches (229 mm) minimum and 27 inches (686 mm) maximum...
-
11B-607.4.2.1 Back wall
Two grab bars shall be installed on the back wall, one located in accordance with Section 11B-609.4 and the other located 8 inches (203 mm) minimum and 10 inches (254 mm) maximum above the...
-
1002.4.4.3 Permitted Protrusions in Wheelchair Spaces
Objects are permitted to protrude a distance of 6 inches (150 mm) maximum along the front of the wheelchair space, where located 9 inches (230 mm) minimum and 27 inches (685 mm) maximum...
-
607.4.2.1 Back Wall
Two grab bars shall be installed on the back wall, one located in accordance with 609.4 and other located 8 inches (205 mm) minimum and 10 inches (255 mm) maximum above the rim of the bathtub...
