In the 2014 NPRM, the Department proposed scoping requirements for captioning devices based on the number of seats in a movie theater. ...
Search Results "Clearance Around Base"
Filters
Commonly Searched Documents
-
6.2. Scoping Requirements
-
Paragraph (f) Prevention of visually induced seizures (Section-by-Section Analysis)
The NPRM suggested that the flash rate for visual indicators be set at or below 3 Hz, based on research for visual fire alarms, and asked (Question 8) whether this value was appropriate....
-
IMPLICATION OF A 19-INCH MINIMUM STANDARD FOR THE HIGHEST POINT IN THE LOWEST ADJUSTABLE POSITION
A 19-inch standard means that any bolsters fit within the highest point standard, thereby making the front edge of the table/chair lower than the bolsters (by about ¾” based on currently...
-
b. Positioning Supports
commenters (manufacturers) recommended providing positioning supports within reach of the patient; one commenter (an accessibility consultant) recommended flexibility to allow for design based...
-
Section 35.152 Detention and correctional facilities—program requirements (Section-by-Section Analysis)
The Department's concerns are based not only on complaints it has received, but the Department's substantial experience in investigations and compliance reviews of jails, prisons, and other...
-
Corbin Russwin Inc. DC46900 Series Safeguard Door Closers
Accommodates minimum door-to-wall clearance on push (closer) side, and 1/8" maximum reveal on pull (holder) side. Minimum top rail: 4"....
-
Horton Automatics ICU/CCU Bi-Fold/Bi-Swing™ Door System
For extra opening width when moving patients or medical equipment, the adjacent Bi-Fold door can be opened along with the Bi-Swing door providing up to 6 ft 8 inches of total clearance....
-
Work Areas [4.1.1(3)]
Recommendations: Space for turning within the work area and interior maneuvering clearances at doors, while not required, should be considered, especially where entrapment may be a concern...
-
5.2 Job Advertisements and Notices
Employers may wish to indicate in job advertisements and notices that they do not discriminate on the basis of disability or other legally prohibited bases....
-
Door and Signal Timing
This provision helps ensure that elevator doors remain open long enough for persons with disabilities to travel from call buttons to the responding car and is based on a travel speed of...
-
2.2 Individual With a Disability
This definition, based on the definition under the Rehabilitation Act, reflects the specific types of discrimination experienced by people with disabilities....
-
403.5.3 Passing Spaces
shall be either: a space 60 inches (1525 mm) minimum by 60 inches (1525 mm) minimum; or, an intersection of two walking surfaces providing a T-shaped space complying with 304.3.2 where the base...
-
1009.2 Pool Lifts
Pool lift seats that consist of materials that resist corrosion and provide a firm base to transfer will be usable by a wider range of people with disabilities....
-
1009.2 Pool Lifts
Pool lift seats that consist of materials that resist corrosion and provide a firm base to transfer will be usable by a wider range of people with disabilities....
-
2. Background
Editorial Committee members representing different stakeholder groups prepared the subsections of Section 2 based largely upon their own expertise and experiences....
-
Roll-in Access [1014.2.2]
When roll-in access is provided, a turning space at least 60 inches in diameter or a T-shaped space with an arm at least 60 by 36 inches and a base at least 36 inches wide and 24 inches...
-
"Qualified Reader" (Section-by-Section Analysis)
Based upon the Department's investigation of complaints alleging that some entities have provided ineffective readers, the Department proposes to define "qualified reader" similarly to "...
-
C.6.ii. - If a Federal agency is distributing a television or multimedia production or a web-cast presentation, does it have to be open or closed captioned and audio-described?
If the production is web-based, regardless of whether it is multimedia, such as a live webcast of a speech, then it must also meet the applicable requirements of 1194.22....
-
Chapter 3: Functional Performance Criteria (Section-by-Section Analysis)
Chapter 3 contains proposed functional performance criteria, which are outcome-based provisions that apply when applicable technical requirements (i.e., Chapters 4 and 5) do not address...
-
5.3.2.1 Size
inches (1,525 millimeters) in diameter or T-shaped with a minimum 60- by 36-inch (1,525 by 915 millimeter) arm and a minimum 36-inch (915 millimeter) -wide by 24-inch (610 millimeter) -long base...
-
Angled (Front-In) Parking
ADAAG's requirement for an access aisle on either side of a space (they can be shared by two spaces) is based on the assumption that drivers can head in or back in as needed....
-
Side Reach [4.2.6]
High and low reaches are based on a depth of reach no greater than 10 inches measured from the available clear floor space....
-
Slope [4.3.7]
Requirements in 4.3, while based on the expectation of level floors, apply equally to exterior sites....
-
5.3.2.1 Size
(1,525 millimeters) in diameter or T-shaped with a minimum 60- by 36-inch (1,525 by 915 millimeter) arm and a minimum 36-inch (915 millimeter) - wide by 24-inch (610 millimeter) -long base...
