The standards contain technical criteria for medical diagnostic equipment that is accessible to and usable by patients with disabilities....
Search Results "Electroacoustic Performance Standards"
Filters
Commonly Searched Documents
-
M101.1 Purpose
-
Panda S.11 Aluminum/Wood Clad Lift & Slide System
Available in silver or black finish which meets the highest performance of AAMA 2605-98....
-
11B-403.3 Slope
. ◼ ETA Editor's Note The 2022 CBC Exception at 11B-403.3 is not present in the 2010 ADA Standards....
-
11B-206.2.4 Spaces and elements
[2010 ADA Standards] 1....
-
11B-233.3.2 Residential dwelling units for sale
[2010 ADA Standards] 233.3.2 Residential Dwelling Units for Sale....
-
11B-610.3 Shower compartment seats
A seat in a standard roll-in shower compartment shall be a folding type, shall be installed on the side wall adjacent to the controls, and shall extend from the back wall to a point within...
-
11B-703.2.4 Character proportions
[2010 ADA Standards] 703.2.4 Character Proportions....
-
11B-703.5.4 Character proportions
[2010 ADA Standards] 703.5.4 Character Proportions....
-
11B-809.4.1 Subsequent bathrooms
ETA Editor's Note The requirement for an accessible shower at subsequent bathrooms prescribed by CBC 11B-809.4.1 is not required by 2010 ADA Standards....
-
11B-703.2.5 Character height
[2010 ADA Standards] EXCEPTION: Where separate raised and visual characters with the same information are provided, raised character height shall be permitted to be ½ inch (13 mm)...
-
11B-1008.2.6 Ground surfaces
Ground surfaces must be inspected and maintained regularly to ensure continued compliance with the ASTM F 1951 standard....
-
E202.7 Best Meets
Where ICT conforming to one or more requirements in the Revised 508 Standards is not commercially available, the agency shall procure the ICT that best meets the Revised 508 Standards consistent...
-
M101.1 Purpose
The proposed standards contain technical criteria for medical diagnostic equipment that is accessible to and usable by patients with disabilities....
-
11B-202.3.1 Prohibited reduction in access
(c) If the 2010 Standards reduce the technical requirements or the number of required accessible elements below the number required by the 1991 Standards, the technical requirements or the...
-
Multiple Single-User Toilet Rooms
Where multiple single-user toilet rooms are clustered in a single location, fifty percent (50%), rather than the one hundred percent (100%) required by the 1991 Standards, are required to...
-
5.2.2.1 Transfer Surface Width Recommendations for M302
recommends 21 inches for the minimum width of the transfer surface of examination chairs and other equipment primarily used by patients in a seated position as described in its proposed standard...
-
B.3.iv - Who makes the determination that a product meets equivalent facilitation?
The vendor may assert that its product meets or exceeds the level of accessibility required by a particular standard through equivalent facilitation....
-
24.1 Q. What types of grab bars should the reinforcement be designed to accommodate and what types may be used if the builder elects to install grab bars in some units at the time of construction?
In determining what is an appropriate grab bar, builders are encouraged to look to the 1986 ANSI A117.1 standard, the standard cited in the Fair Housing Act....
-
§ 36.304(d)(2)(iii)
., elements for which there are neither technical nor scoping specifications in the 1991 Standards), and therefore those elements must be modified to the extent readily achievable to comply...
-
Alterations and Additions
This guide provides an introduction to the scoping requirements that form the basis for the Department of Justice’s 2010 ADA Standards and the Department of Transportation's ADA Standards...
-
11B-202.3.1 Prohibited reduction in access
(c) If the 2010 Standards reduce the technical requirements or the number of required accessible elements below the number required by the 1991 Standards, the technical requirements or the...
-
INTRODUCTION
These changes include revised accessibility standards, called the 2010 Standards for Accessible Design (2010 Standards), which establish minimum criteria for accessibility in design and...
-
11B-201.1 Scope
[ADA Title III] §36.406(b) Standards for New Construction and Alterations; Scope of Coverage....
-
M101.1 Purpose (Section-by-Section Analysis)
The MDE NPRM proposed that the purpose of the MDE Standards was to establish technical criteria for diagnostic equipment that is accessible to and usable by patients with disabilities and...
