The clear floor area width dimension also informs the minimum clearance width for successful passage through corridors, doorways, and wheelchair ramps....
Boost Your Business - Chapter 7 - Halls and Fountains
Primary measures: maximum and minimum heights attained, preferred seat width, WMD angle and position Protocol E: Two-Step with Ramp...
Construction Specification Institute While developing suggested tolerances for surface materials, the Construction Specifications Institute developed a suggested method for measuring ramp...
The station was designed to investigate the impact handhelds, back rests, heights, and seat widths have on transfer performance....
Such measures include, for example, providing a ramp with a steeper slope or widening a doorway to a narrower width than that mandated by the alterations requirements....
The term “circulation paths” used in Section 802.1.5 means aisle width required by applicable building or life safety codes for the specific assembly occupancy....
The term "circulation paths" used in Section 11B-802.1.5 means aisle width required by applicable building or life safety codes for the specific assembly occupancy....
o 1 side of platform for dual ramp entry of platform o 2 sides of platform for single ramp entry with 34” minimum width between standing supports o The standing supports need to be tied...
Such measures include, for example, providing a ramp with a steeper slope or widening a doorway to a narrower width than that mandated by the alterations requirements....
In shared use paths, the width of curb ramps runs and blended transitions shall be equal to the width of the shared use path. R305.1.4 Size....
A 36 inches minimum (914 mm) width side clearance shall be provided along the entire length of one side of adult changing tables....
(§503.5) B4 Is a curb ramp provided if a curb separates the access aisle from the accessible route to the accessible entrance?...
Section 408.4.1 covers the current ADA Standards for the car dimensions and doors of limited-use/limited-application elevators.
When the running slope of a walking surface exceeds 5%, it must comply with the accessibility requirements for ramps....
Such doors would have to provide at least 32 inches nominal clear width when the door is open 90 degrees, measured between the face of the door and the stop....
Because such individual garages attached to and serving only one covered multifamily dwelling typically are not finished living space, the garage is not required to be accessible in terms of width...
Slip Resistant Surface—Aisles, Steps, Floor Areas Where People Walk, Floor Areas in Securement Locations, Lift Platforms, Ramps Slip resistance is based on the frictional force necessary...
Requirements in 403 for walking surfaces apply to portions of accessible routes existing between doors and doorways, ramps, elevators, or lifts....