The slopes of beach access routes shall comply with 1018.7.
Search Results "Fire-Building Surface"
Commonly Searched Documents
-
1018.7 Slopes
-
1014.2.1.2 Floor Height
The camp shelter floor at the entrance shall be 19 inches (485 mm) high maximum measured from the clear ground space.
-
1.2.5 Ramps
1.2.5 Ramps. When overall running slope and cross slope for accessible ramps are measured according to Sections 1.1.11 a recommended tolerance for these slopes is +0.5%. In the...
-
201.3 Temporary and Permanent Structures
These requirements shall apply to temporary and permanent buildings and facilities. Advisory 201.3 Temporary and Permanent Structures....
-
4.1.7(2)(a)(ii) ADA Application
Where alterations are undertaken to a qualified historic building or facility that is subject to section 106 of the National Historic Preservation Act, the Federal agency with jurisdiction...
-
11B-201.3 Temporary and permanent structures
These requirements shall apply to temporary and permanent buildings and facilities. Advisory 11B-201.3 Temporary and permanent structures....
-
Section 36.405 Alterations: Historic Preservation (Preamble, Section-by-Section Analysis)
Therefore, the language of this section has been revised to make it clear that this provision applies to buildings or facilities that are eligible for listing in the National Register of...
-
CASI California Survey Reports Acceptance Criteria - Equivalent Facilitation AC 01-12
Therefore as a matter of purpose, this document identifies critical issues of code which must be addressed to assure that buildings, structures and related facilities are accessible to,...
-
5.3.3 Transfer Sides Recommendations for M302
transfer onto the short side and the long side of the surface....
-
M304.2.2 Standing Supports (Section-by-Section Analysis)
The MDE NPRM proposed requiring standing supports on each side of the standing surface of diagnostic equipment used by patients in the standing position, and compliance with the technical...
- Diversified Woodcrafts - Forward Vision & Brad (Teacher Series) Promotional Video
- Diversified Woodcrafts Lab Table Assembly Video
- Teknion Journal
- Diversified Woodcrafts 9010 ARM Lab Table Accessory
-
1016.8.3 Slope
Where the surface is other than asphalt, concrete, or boards, slopes not steeper than 1:20 are permitted when necessary for drainage....
-
M302.2.4 Transfer Sides
Options to transfer from a mobility device shall be provided on two adjoining sides of transfer surfaces. ...
-
F216.1 General
Building directories, menus, seat and row designations in assembly areas, occupant names, building addresses, and company names and logos shall not be required to comply with F216. 2....
-
216.1 General
Building directories, menus, seat and row designations in assembly areas, occupant names, building addresses, and company names and logos shall not be required to comply with 216. 2....
-
216.1 General
Building directories, menus, seat and row designations in assembly areas, occupant names, building addresses, and company names and logos shall not be required to comply with 216. 2....
-
Section 4.26.2
• Section 4.26.2 of the 1991 Standards requires handrail gripping surfaces to have a diameter of 1 ¼ inches to 1 ½ inches, or to provide an equivalent gripping surface....
-
1016.8.3 Slope
EXCEPTION: Where the surface is other than concrete, asphalt, or boards, slopes not steeper than 1:20 shall be permitted when necessary for drainage....
-
1016.8.3 Slope
EXCEPTION: Where the surface is other than concrete, asphalt, or boards, slopes not steeper than 1:20 shall be permitted when necessary for drainage....
- Populas Vox Perfect Corner Workstation
-
Exit Stairway Enclosures [IBC §1007.3 and 1019 (2003), §1003.2.13.2 and 1005.3.2 (2000)]
The IBC contains requirements for exit stairway enclosures that address fire-resistance and smoke protection, stairways and handrails, signs, and other features....
