change supervisors, the ADA may require that supervisory methods be altered as a form of reasonable accommodation.(99) Also, an employee with a disability is protected from disability-based...
Search Results "Clearance in Base"
Filters
Commonly Searched Documents
-
33. Does an employer have to change a person's supervisor as a form of reasonable accommodation?
-
7. Alternatives
We considered two alternative approaches to updating the existing 508 Standards and 255 Guidelines: In the 2010 ANPRM, the Board proposed a set of requirements that were based on...
-
Character Height [4.30.3]
The viewing location upon which calculations are based may be difficult to pinpoint in long corridors and large rooms....
-
12101(a)(7)
minority who have been faced with restrictions and limitations, subjected to a history of purposeful unequal treatment, and relegated to a position of political powerlessness in our society, based...
-
End Note
Or, call the toll-free ADA Information Line: 800-514-0301 (voice) • 800-514-0383 (TTY) Expanding Your Market: Building a Diverse Customer Base (PDF version) June 2006 Duplication...
-
D. Functional Performance Criteria and Technical Requirements (Section-by-Section Analysis)
The proposed requirements in Appendix C are based on recommendations from the Advisory Committee unless otherwise noted....
-
Q. How does the ADA recognize public health concerns?
The ADA recognizes the need to strike a balance between the right of a disabled person to be free from discrimination based on unfounded fear and the right of the public to be protected...
-
§ 38.23(c)(1) Design load
Ramps 30 inches or longer shall support a load of 600 pounds, placed at the centroid of the ramp distributed over an area of 26 inches by 26 inches, with a safety factor of at least 3 based...
-
11B-233.3.1.2.6.4 Test number three, unusual characteristics test
subject to other similar requirements of law or code that require the lowest floor or the lowest structural member of the lowest floor be designed to a specified level at or above the base...
-
Just Manufacturing Classroom Concealed Ledgemount Teardrop Handles Restricted Swing Faucet
High rise spout with 10-5/8" clearance. 70 degree restricted swing spout. Replaceable seats. Brass Quarter turn stem units....
-
Just Manufacturing Concealed Classroom Faucet with High Rise Spout
High rise spout with 10-5/8" clearance. 70 degree restricted swing spout. Replaceable seats. Brass Quarter turn stem units....
-
CRL Jackson 900 Series Floor Mounted Door Closers
The 1/8" (3 mm) collar height Spindle is supplied with the door closer, providing a 5/16" (8 mm) clearance from finished floor to door bottom....
-
Edge Protection
Toe clearance must be at least 30 inches wide and a minimum of 9 inches above the ground or deck surface beyond the railing....
-
226.1 General
However, employers should consider work surfaces that are flexible and permit installation at variable heights and clearances....
-
Locating Controls & Devices: Percent of People Who Can Reach the Matrix Cell Indicated While Holding No Weight - Forward Approach Manual Wheelchair
reaching over an obstruction in relation to the forward-most point, and the negative range implying that the reach target is brought closer to the person (such as on a table with knee clearance...
-
Locating Controls & Devices: Percent of People Who Can Reach the Matrix Cell Indicated While Holding 5 lb Weight - Forward Approach Scooter
reaching over an obstruction in relation to the forward-most point, and the negative range implying that the reach target is brought closer to the person (such as on a table with knee clearance...
-
Locating Controls & Devices: Percent of People Who Can Reach the Matrix Cell Indicated While Holding No Weight - Forward Approach Power Chair
reaching over an obstruction in relation to the forward-most point, and the negative range implying that the reach target is brought closer to the person (such as on a table with knee clearance...
-
Landings [§405.7]
Handrails, edge protection, vertical posts and other elements cannot obstruct or overlap the minimum 60” by 60” clearance....
-
4) Medical or health care facilities
Required clearances in rooms exceed ADAAG requirements. No special, less stringent requirements for alterations (§6)....
-
M305.3.1 Length
The length of gripping surfaces for standing supports shall be based on the position of the standing supports in relation to the standing surfaces they serve....
-
218 Transportation Facilities
These provisions are based on requirements located in Chapter 10 in the proposed rule....
-
1009.5.2 Transfer Space
A transfer space of 60 inches (1525 mm) minimum by 60 inches (1525 mm) minimum with a slope not steeper than 1:48 shall be provided at the base of the transfer platform surface and shall...
-
703.2.5 Character Height
Character height measured vertically from the baseline of the character shall be 5/8 inch (16 mm) minimum and 2 inches (51 mm) maximum based on the height of the uppercase letter “I”....
-
M301.2.2, M302.2.2 Transfer Size
This transfer surface is located on the longitudinal (long) side of the stretcher—either right or left side Rationale: Based upon full committee discussion and harmonization with Exam...
