Handrails [§504.6, §505] Handrails are required on both sides of stairs and must be continuous within the full length of each stair flight. Inside handrails on switchback or...
Search Results "Check Writing Surface"
-
Handrails [§504.6, §505]
-
Objective Surface Measurements
Objective Surface Measurements For purposes of comparison, objective surface measurement data are included from the “Measurement of Surface Characteristics for Accessibility” NIH-funded...
-
11B-1009.5.5 Surface
The surface of the transfer system shall not be sharp and shall have rounded edges....
-
Section A: Parking
(§502.5) A4 Are designated accessible parking spaces and the access aisles serving them on a level surface, with slopes not exceeding 1:48 in all...
-
11B-407.4.10.2 Surfaces
Support rails shall be smooth and any surface adjacent to them shall be free of sharp or abrasive elements....
-
Conclusion
During this second phase of the independent wheelchair transfer study, platform transfers with and without grab-bars and a backrest and two-step transfers were evaluated. The study...
-
5.4.3 Transfer Support Height for Equipment Used in a Supine, Prone, Side-Lying, or Seated Position
Transfer supports should be positioned 6 inches minimum and 19 inches maximum above the transfer surface....
-
Example 1: With Cooking Facilities
With Cooking Facilities An employee break room with fixed or built-in range cooking facilities shall comply with the requirements of 212 and 804 for kitchens and kitchenettes....
-
Designing Sidewalks and Trails for Access, Part II of II: Best Practices Design Guide
Source: U.S. Department of Transportation / Beneficial Designs, Inc. Document: 484 pages (9.30 MB PDF) Publication Date: September 2001 This guidebook is the second part of...
-
Table Surface Height
Persons with disabilities considered the 34 inch maximum height too high for surfaces used for any length of time....
-
Manual Doors and Gates [§404.2]
Manual Doors and Gates [§404.2]
-
Summary of Costs and Benefits
We compared the final rule to guidelines and standards used by the federal agencies for the design of outdoor developed areas without regard to accessibility to determine whether the...
-
11B-1009.4.4 Surface
Surfaces of transfer walls shall not be sharp and shall have rounded edges....
-
11B-1009.5.5 Surface
The surface of the transfer system shall not be sharp and shall have rounded edges....
-
11B-1009.5.5 Surface
The surface of the transfer system shall not be sharp and shall have rounded edges....
-
11B-1009.4.4 Surface
Surfaces of transfer walls shall not be sharp and shall have rounded edges....
-
5a. Ramp Surface
Is the ramp surface at least 36 inches wide, excluding flared sides? [ADA Stds 4.7.3] Yes _____ No _____...
-
302 Floor or Ground Surfaces
Section 302 requires floor or ground surfaces to be stable, firm, and slip resistant and provides specifications for carpets and surface openings. Comment....
-
Guest Rooms
Carpet causes resistance that makes rolling much more difficult than on the aforementioned surfaces....
-
704.7 Unexposed surface temperature
Where protected openings are not limited by Section 704.8, the limitation on the rise of temperature on the unexposed surface of exterior walls the exterior wall in any story, the total...
-
R305 Detectable Warning Surfaces
R305 Detectable Warning Surfaces...
-
Bathroom Accommodating Reduced Ambulatory Mobility
Ceiling lift between the bathtub and toilet (this is actually fun to use) – reinforcement less than $50 Chromatherapy bathtub for relaxation FSC certified maple...