Requirement 6 present design standards for installation of reinforcement in bathroom walls to allow for later installation of grab bars around the toilet, tub, shower stall and shower seat...
Search Results "Fixed Assembly Seating"
Commonly Searched Documents
-
Guidelines for Requirement 6
-
5.4.1 Transfer Support Location for M301 and M302
transfer surface that is opposite the transfer side (M301.2.3 and M302.2.3) similar to the provisions in the 2010 Standards for grab bars provided at bathtubs and shower compartments with seats...
-
i. Medical examination and treatment tables and chairs
i. Medical examination and treatment tables and chairs Healthcare providers use examination and treatment tables and chairs for many different types of medical and dental...
-
Technical Memorandum TM 2013-19 Private Toilet and Bathing Rooms
Water Closets 604.4, Exception 1: Seats 604.5, Exception 1: Grab Bars. Lavatories and Sinks 606.2, Exception 2: Clear Floor Space 606.3, Exception 1: Height....
-
Section 36.406(b) Application of Standards to Fixed Elements
Section 36.406(b) Application of Standards to Fixed Elements The final rule contains a new Sec. 36.406(b) that clarifies that the requirements established by this section, including those...
-
5.1.3 Transfer Surface Low Height Options for M301 and M302
The Committee shifted focus from a fixed height range between 17 to 19 inches as adjustability was accepted....
- Pressalit Care VALUE Support Arm Fixed Height Swing Grab Bar
-
Plan 3A: 12-Foot Wide Accessible Guest Room
Features include a bathtub with a seat, comparable vanity, open clothes closet, and door connecting to adjacent guest room....
-
Plan 1A: 13-Foot Wide Accessible Guest Room
Features include a standard bathtub with a seat, comparable vanity, clothes closet with swinging doors, and door connecting to adjacent guest room....
-
M101.2 Application (Section-by-Section Analysis)
The first is to exempt examination chairs which comply with M302 and can be reclined to facilitate diagnosis after the patient transfers onto the seat from complying with M301....
-
Audible Communication
an audio amplification system or an occupant load of 50 or more people and have fixed seating....
-
17 Inch Low Height
The safest and most easily accessible transfers are those with no or very little horizontal and vertical distance between the seat of the wheelchair and the transfer surface....
-
§ 38.125(d) Seating
(d) Seating—...
-
5.1.4 Transfer Surface Height Measurement
The transfer surface height should be measured from the floor to the highest point on the seat in an uncompressed state, inclusive of bolsters....
-
Does a wheelchair user have to use the seat belt and shoulder harness?
For example, on fixed route buses, if none of the other passengers are required to wear shoulder belts then neither can the person in the mobility device be required to do so....
-
Chapter 3: Study findings
[See subsections ...]
-
4.34.5.4 BATHTUBS
If a bathtub is provided, then it shall have the following features:
- Midmark Ritter 223 Barrier-Free® Power Examination Table
- Midmark Ritter 222 Barrier-Free® Power Examination Table
-
AMUSEMENT RIDE SEAT
[DSA-AC] A seat that is built-in or mechanically fastened to an amusement ride intended to be occupied by one or more passengers....
-
AMUSEMENT RIDE SEAT
[DSA-AC] A seat that is built-in or mechanically fastened to an amusement ride intended to be occupied by one or more passengers....
-
Does a wheelchair user have to use the seat belt and shoulder harness?
For example, on fixed route buses, if none of the other passengers are required to wear shoulder belts then neither can the person in the mobility device be required to do so....
-
5.4.7 Transfer Support Gripping Surface Clearance Recommendation for M301 and M302
gripping surface would be appropriate for transfer supports on diagnostic equipment used by patients in a supine, prone, or side-lying position, and diagnostic equipment used by patients in a seated...
-
4. Wheelchair seat depth
Wheelchair seat depth For this study, wheelchair seat depth was calculated as the horizontal distance from the proximal (i.e., towards the rear) edge to the distal (i.e., towards the...