Running, cross, and side slopes of curb ramps that are excessively steep; ii. Ramps that are too narrow to accommodate wheelchairs or scooters; iii....
Search Results "Counter Slope"
Filters
Commonly Searched Documents
-
INTRODUCTION
-
Using the Conditions for an Exception in FSORAG
The terrain makes it impossible to meet the technical requirement for running slope without severe cuts or fills....
-
BACKGROUND
who have mobility disabilities cannot access their physician's office, located in Suite 103 of the Office Building, due in part to inaccessible outer doors on the building and steep ramp slopes...
-
General [4.5.1]
Many variables affect the performance of a given walking surface, including slope and cross slope, its material, jointing, texture, and finish, the presence of moisture or contaminants,...
-
Exemptions for Entire Trail or Beach Access Route
The proposed rule would have exempted an entire trail from complying with the technical requirements for trails when: The combination of running slope and cross slope exceeds 40...
-
Installation of Aggregate Surfaces at Bradford Woods
Woods conformed to the following protocol: Prior to installing the crushed rock (aggregate) surfacing material, the trail bed shall be shaped to reflect the same linear grade and cross slope...
-
Summary: What Every Playground Owner Should Know About the Accessibility of Their Playground Surfaces
The areas should be checked for compliance with running slope, cross slope, changes in level and openings. Comparison shopping is essential in the planning process....
-
Handrails Requirement
., those with running slopes no steeper than 1:20), meet the technical criteria in section 505....
-
Maneuvering Space
permits individuals with mobility devices to turn around A 60-inch (1525 mm) T-Shaped turn allows an individual to change directions by making a series of multi-point turns Slope...
-
R302.5 Grade
Running slope requirements are contained in R304.2.2 for perpendicular curb ramps, in R304.3.2 for parallel curb ramps, in R304.4.1 for blended transitions, and in R407.2 for ramps....
-
R302.7.2 Vertical Surface Discontinuities
Vertical surface discontinuities between 6.4 mm (0.25 in) and 13 mm (0.5 in) shall be beveled with a slope not steeper than 50 percent....
-
Ramp
For example, some amusement park rides have sloped surfaces built into the structure of the ride vehicle to help individuals transfer into and out of the vehicle. ...
-
4.33.3* Placement of Wheelchair Locations
EXCEPTION: Accessible viewing positions may be clustered for bleachers, balconies, and other areas having sight lines that require slopes of greater than 5 percent....
-
505.6 Gripping Surface
Where handrails are provided along walking surfaces with slopes not steeper than 1:20, the bottoms of handrail gripping surfaces shall be permitted to be obstructed along their entire length...
-
The SmartWheel
Although providing very accurate data and the ability to extrapolate to longer intervals, there still needs to be a standard for slope, flatness, and smoothness at longer intervals....
-
11B-705.1.2.2.2.1 One entrance/exit point
Where the turning space has one entrance/exit point other than the sloped ramp segments, detectable warnings shall be 36 inches (914 mm) deep, as measured perpendicular to the curb, and...
-
11B-205.1 General
Where two or more outlets are provided in a kitchen above a length of counter top that is uninterrupted by a sink or appliance, one outlet shall not be required to comply with 309....
-
Plan 5A: 13-Foot Wide Accessible Guest Room
The following accessible features are provided in the bathroom: • Comparable vanity counter top space (section 806); • Transfer shower (section 603.2); • Shower seat (section 610.3...
-
606.2 Clear Floor Space
knee clearance of 24 inches (610 mm) minimum above the finish floor or ground shall be permitted at lavatories and sinks used primarily by children 6 through 12 years where the rim or counter...
-
606.2 Clear Floor Space
knee clearance of 24 inches (610 mm) minimum above the finish floor or ground shall be permitted at lavatories and sinks used primarily by children 6 through 12 years where the rim or counter...
-
206.2.8 Employee Work Areas
Common use circulation paths located within employee work areas that are less than 1000 square feet (93 m²) and defined by permanently installed partitions, counters, casework, or furnishings...
-
FEEDING + COMMODITY DISTRIBUTION
Examples of standard items include: food, water, cots, blankets, clothing, Diabetes testing strips, mobility aids, and over-the-counter medicine....
-
606.2 Clear Floor Space
knee clearance of 24 inches (610 mm) minimum above the finish floor or ground shall be permitted at lavatories and sinks used primarily by children 6 through 12 years where the rim or counter...