EXCEPTION: Accessible viewing positions may be clustered for bleachers, balconies, and other areas having sight lines that require slopes of greater than 5 percent....
Search Results "Counter Slope"
-
4.33.3* PLACEMENT OF WHEELCHAIR LOCATIONS
-
Is there a minimum distance between changes in level?
used to span vertical changes greater than ½”, must have level landings and clearances at the tops and bottoms of each run to provide adequate separation and resting intervals between sloping...
-
11B-303.3 Beveled
Changes in level between ¼ inch (6.4 mm) high minimum and ½ inch (12.7 mm) high maximum shall be beveled with a slope not steeper than 1:2....
-
11B-1005.1 Accessible routes
length of the gangway or series of gangways serving as part of a required accessible route is 30 feet (9144 mm) minimum, gangways shall not be required to comply with Section 11B-405.2 _|Slope...
-
4.1 Introduction
One obvious example of the need to revise standards is that WhMD users who require the highest knee clearances cannot be accommodated without making some radical changes to the design of counters...
-
4.4 Knee and Toe Clearances
The results clearly provide evidence that adjustable and adaptable counters and toe kicks are a valuable design strategy....
-
ALUMAT Magnetic Doors Seals for External Doors
For convenient and low-noise handling while opening the doors, the magnet counter profiles below the doors have additional insulating strips....
-
Neo-Metro Commercial Curved Front, Wall Mounted System M2 Basin 8980 Series
These units offer the look and feel of commercial-grade designer basins and counter tops. Each standard height washbasin complies with ANSI, UFAS and ADA requirements....
-
IPS Corporation Truebro® Basin Guard® Undersink Protective Enclosures
Basin Guard can be installed where ever counter tops and sidewalls are present and the proper ADA sink is installed....
-
Vehicle Parking
Do not allow the slope of the vehicle parking area to exceed 1:48 (2 percent) in any direction....
-
Re: American Specialties 9014 Surface Mounted Horizontal Baby Changing Station
The design of the hand hold is completely sloped at about 45 degrees. My fingers slipped off unless I applied tremendous pinching force to operate....
-
Appendix 2: Survey Forms: Curb Ramps
Y N Y N Y N Y N Y N Y N Y N 2 Does CR have a running slope of 8.33% or less?...
-
11 [§ 4.7.6]
Built-up curb ramps should have flared sides with a slope of 10 percent or less or have edge protection and handrails on the sides....
-
303.3 Beveled
Changes in level between ¼ inch (6.4 mm) high minimum and ½ inch (13 mm) high maximum shall be beveled with a slope not steeper than 1:2. Advisory 303.3 Beveled....
-
Accessible Routes
The accessible route must comply with ADAAG provisions for the location, width (minimum of 36 inches), passing space, head room, surface, slope (maximum of 1:12 or 8.33%), changes in level...
-
Accessible Routes
Accessible route requirements in ADAAG address width (minimum of 36 inches), passing space, head room, surface, slope (maximum of 1:12 or 8.33%), changes in level, doors, egress, and areas...
-
Comments from Individuals Who Are Blind or Have Low Vision (Section-by-Section Analysis)
member of the advisory committee that recommended the proposed guidelines, but filed a minority report recommending detectable warning surfaces should be required only on curb ramps with slopes...
-
R304.1 General
There are two types of curb ramps: • Perpendicular curb ramps have a running slope that cuts through or is built up to the curb at right angles or meets the gutter break at right angles...
-
Suggested accessibility guidelines for exterior concrete surfaces
The deviation from slope or plane of formed surfaces over 10 feet (3 m) is ± 0.3% of length. This is approximately 3/8 inch in 10 feet (10 mm in 3 m)....
-
Whitehall Mfg. WH2142T2 Ligature Resistant Toilet Top Supply On-Floor Wall Waste
To comply with Ligature-Resistant needs, an optional sloped top cover (box) with a Top Supply flush valve is available. This toilet is configured for a wall waste application....
-
Salsbury Industries See Through Metal Locker Six Tier Box Style 1 Wide
combination or key padlocks and electronic locks Salsbury Industries is an ISO 9001: 2008 certified company and has excelled in the field of manufacturing since 1936 Options Sloping...
-
Salsbury Industries See Through Metal Locker Six Tier Box Style Bridge 16 Box
padlocks and factory installed electronic locks Salsbury Industries is an ISO 9001: 2008 certified company and has excelled in the field of manufacturing since 1936 Options Sloping...
-
Salsbury Industries 66000 Series Six Tier Box Style 1 Wide Standard Metal Lockers
combination or key padlocks and electronic locks Salsbury Industries is an ISO 9001: 2008 certified company and has excelled in the field of manufacturing since 1936 Options Sloping...
-
Salsbury Industries See Through Metal Locker Six Tier Box Style 3 Wide
combination or key padlocks and electronic locks Salsbury Industries is an ISO 9001: 2008 certified company and has excelled in the field of manufacturing since 1936 Options Sloping...
