Knee clearance shall extend 25 inches (635 mm) maximum under an element at 9 inches (230 mm) above the finish floor or ground....
Search Results "Clearance Around Base"
-
306.3.2 Maximum Depth
-
1002.5.3 Transfer Entry
Where openings are provided for transfer to amusement ride seats, the openings shall provide clearance for transfer from a wheelchair or mobility aid to the amusement ride seat....
-
3.0 Comparison of Research Methodologies
Participants in the DETR study were recruited at an exposition of equipment for people who use wheeled mobility devices for traveling around the community....
- Walk-A-Sured Roll-On Anti-Slip Safety Coating System
- Kompan, Inc. Solitaires Spinners Navigator ELE400007
- Walk-A-Sured Clear Anti-Slip Safety Coating System
-
Truncated Domes
The proposed rule specified that the truncated domes have a diameter of 0.9 inch, measured at the base....
- Wooster Products Anti-Slip Safety Coatings Systems
-
Height – M301.2.1 & M302.2.1
Upon consideration of the subcommittee’s final recommendation, the full committee was unable to come to a consensus around any specific low height requirement, nor the “best practice” recommendation...
-
11. Do not use language that perpetuates negative stereotypes about psychiatric disabilities.
Much work needs to be done to break down stigma around psychiatric disabilities....
-
608 Shower Compartments
Section 608 addresses transfer showers and roll-in showers and provides specifications for size and clearances, grab bars, seats, operable parts, shower spray units, thresholds, and enclosures...
-
1009.4.5 Grab Bars
Where one grab bar is provided, clearance shall be 24 inches (610 mm) minimum on both sides of the grab bar....
- Nana Wall Systems, Inc. Sliding Glass Walls With Solid Wood HSW66
-
11B-305.7.2 Parallel approach
FIGURE 11B-305.7.2 MANEUVERING CLEARANCE IN AN ALCOVE, PARALLEL APPROACH...
-
11B-305.7.1 Forward approach
FIGURE 11B-305.7.1 MANEUVERING CLEARANCE IN AN ALCOVE, FORWARD APPROACH...
-
705.1.2 Dome Spacing
Truncated domes in a detectable warning surface shall have a center-to-center spacing of 1.6 inches (41 mm) minimum and 2.4 inches (61 mm) maximum, and a base-to-base spacing of 0.65 inch...
-
SECTION#4
SECTION#4 For the following questions, please answer every item pertaining to the sub-base installation, if the sub-base installation was necessary due to the installation of the trail...
-
705.1.2 Dome Spacing
Truncated domes in a detectable warning surface shall have a center-to-center spacing of 1.6 inches (41 mm) minimum and 2.4 inches (61 mm) maximum, and a base-to-base spacing of 0.65 inch...
-
How Overgrown Foliage Renders Your Home Security System Completely Useless
A high-powered, motion-activated floodlight cannot illuminate the driveway if a thick branch is wrapped tightly around the fixture....
-
Line of Sight and Dispersion of Wheelchair Spaces in Assembly Areas
This performance standard is based upon the underlying principle of equal opportunity for a good viewing experience for everyone, including persons with disabilities....
-
Requirement 6. Reinforced walls for grab bars.
designed and constructed in such a manner that all premises within covered multifamily dwelling units contain reinforcements in bathroom walls to allow later installation of grab bars around...
-
Foot Travel on Trails and Roads With Restrictions
Department of Agriculture has determined that a minimum of 36 inches (915 millimeters) of clear passage must normally be provided around or through the gate, berm, or other restrictive device...
- Schumacher: Introduction to Schumacher Elevator Company
-
T504.1 General
Passenger access routes shall provide clearances that are sufficient to permit passengers using wheelchairs to move between wheelchair spaces and doorways that provide accessible boarding...