Toilet paper dispensers shall comply with 309.4 and shall be 7 inches (180 mm) minimum and 9 inches (230 mm) maximum in front of the water closet measured to the centerline of the dispenser...
Search Results "Feasibility (Technical, Infeasible, Structural, Maximum Extent)"
Commonly Searched Documents
-
11B-604.7 Dispensers and disposal units
-
20. Q: What about holding cells and jails that are not accessible?
A law enforcement agency must make structural changes, if necessary, or arrange to use a nearby accessible facility....
-
Remanufactured or rebuilt vehicles must be accessible
If a remanufactured or rebuilt vehicle will not be accessible, the grantee must submit information to FTA demonstrating that the structural integrity of the vehicle would be significantly...
-
1.1.3 Scope
shall apply to the construction, alteration, movement, enlargement, replacement, repair, equipment, use and occupancy, location, maintenance, removal and demolition of every building or structure...
-
1.1.3 Scope
shall apply to the construction, alteration, movement, enlargement, replacement, repair, equipment, use and occupancy, location, maintenance, removal and demolition of every building or structure...
-
1.1.3 Scope
shall apply to the construction, alteration, movement, enlargement, replacement, repair, equipment, use and occupancy, location, maintenance, removal and demolition of every building or structure...
-
Sec.36.504(a)(1)
(1) May grant any equitable relief that such court considers to be appropriate, including, to the extent required by the Act or this part --...
-
§ 36.504(a)(1)
(1) May grant any equitable relief that such court considers to be appropriate, including, to the extent required by the Act or this part—...
-
Accessible Teeing Grounds, Putting Greens, and Weather Shelters
Standards provide an exception for existing golf courses with three or more teeing grounds not to provide golf car passage to the forward teeing ground where terrain makes such passage infeasible...
-
12206(e) Failure to Receive Assistance
--An employer, public accommodation, or other entity covered under this Act shall not be excused from compliance with the requirements of this Act because of any failure to receive technical...
-
12206(e) Failure to receive assistance
employer, public accommodation, or other entity covered under this chapter shall not be excused from compliance with the requirements of this chapter because of any failure to receive technical...
-
30. Q: I still have some general questions about the ADA. Where can I get more information?
Information Specialists are available to answer general and technical questions during business hours on the weekdays....
- Adaptive Engineering Inc. Mobilift CX Wheelchair Lift
-
Circular Cross Section: ADA Standard Section 505.7.1
Section 505.7.1 covers the current ADA Standards for the circular cross section of handrail gripping surfaces.
-
Character Proportions: ADA Standard Section 703.2.4
Characters shall be selected from fonts where the width of the uppercase letter “O” is 55 percent minimum and 110 percent maximum of the height of the uppercase letter “I”....
-
Character Proportions: ADA Standard Section 703.5.4
Characters shall be selected from fonts where the width of the uppercase letter “O” is 55 percent minimum and 110 percent maximum of the height of the uppercase letter “I”....
-
Height: ADA Standard Section 902.3
The tops of dining surfaces and work surfaces shall be 28 inches (710 mm) minimum and 34 inches (865 mm) maximum above the finish floor or ground....
-
Transfer Height: ADA Standard Section 1002.6.2
The height of transfer device seats shall be 14 inches (355 mm) minimum and 24 inches (610 mm) maximum measured from the load and unload surface....
-
11B-505.7.1 Circular cross section
Handrail gripping surfaces with a circular cross section shall have an outside diameter of 1¼ inches (32 mm) minimum and 2 inches (51 mm) maximum....
-
1009.6.1 Travel distance
The maximum travel distance from any accessible space to an area of refuge shall not exceed the exit access travel distance permitted for the occupancy in accordance with Section 1017.1....
-
11B-1002.6.2 Transfer height
The height of transfer device seats shall be 14 inches (356 mm) minimum and 24 inches (610 mm) maximum measured from the load and unload surface....
-
11B-902.3 Height
The tops of dining surfaces and work surfaces shall be 28 inches (711 mm) minimum and 34 inches (864 mm) maximum above the finish floor or ground....
-
11B-809.10.7.4 Seat height
Water closet seats shall be 15 inches (381 mm) minimum and 19 inches (483 mm) maximum measured to the top of the seat above the finish floor....
-
Sec. 469.107(2)
(2) issue a certification that a structure not otherwise subject to this chapter is free of architectural barriers and in compliance with this chapter....