Rough Wall Opening: 11 1/4" W, 15 5/8" H, 4" min. depth (285 x 395 x 100mm)....
Search Results "Water Depth"
Commonly Searched Documents
- Bobrick ClassicSeries Recessed Sanitary Napkins Disposal B-353
-
806.2.4 Toilet and Bathing Facilities
No fewer than one water closet, one lavatory, and one bathtub or shower shall comply with applicable requirements of 603 through 610....
-
Handrail Extensions
If handrail extensions are provided, they do not need to be parallel with the ground or floor surface, since the surface may be moving due to water conditions....
-
Flush Controls On Toilets
With requirement's for saving of water within certain jurisdictions there are a number of toilets out there with the flush control as a button on the top of the tank. ...
-
Re: Service Counters
For code compliance, one must create a reasonable standard for sufficient depth for accessible use. Reasonable persons will disagree on that number. Why bother? ...
- American Standard Exposed Manual Top Spud Urinal 0.5 gpf Flush Valve 6045.051
-
M305.2.2 Length (Section-by-Section Analysis)
there was no requirement for length of the transfer support; however, the MDE NPRM preamble noted that the Access Board was considering requiring the transfer supports to extend the entire depth...
-
M301.3.1 Transfer Supports
A) For transfer depths less than or equal to 24 inches a transfer support will be located opposite the transfer side....
-
Moisture and Durability
The trendline fitted to the data of the moisture profile in E2 indicates that it is saturated at a depth of approximately 100 mm (4”) and continues to be saturated to the drainage bed....
-
How to Measure Transfer Surface Height
The lower wheelchair illustrates a typical diagonal transfer.24 Figure 11: Corner radii of a medical examination table The depth and width are measured along the centerlines of...
-
Recommended Objective Test Method and Performance Specifications
Firmness Penetration Depth Firmness Rating Firm 0.3 inch or less 3 or lower Moderately Firm >0.3 to 0.5 inch >3 to 5 Not...
-
2.6
with lines of sight comparable to those for members of the general public, (b) including wheelchair spaces as an integral part of the fixed seating plan, (c) providing the appropriate depth...
-
11B-809.2.2 Turning space
Exception: Turning space shall not be required in exterior spaces 30 inches (762 mm) maximum in depth or width. [2010 ADAS] Advisory 809.2.2 Turning Space. ...
-
Alterations: Alternate Stalls
Alternate designs in ADAAG Figure 30(b) allow narrower stall widths while requiring greater depth....
-
11B-809.2.2 Turning space
Exception: Turning space shall not be required in exterior spaces 30 inches (762 mm) maximum in depth or width. [2010 ADAS] Advisory 809.2.2 Turning Space....
-
11B-809.2.2 Turning space
Exception: Turning space shall not be required in exterior spaces 30 inches (762 mm) maximum in depth or width. Advisory 11B-809.2.2 Turning space....
- Innerface Clearview Interior Signage
- Bobrick ClassicSeries Recessed Sanitary Napkin Disposal and Toilet Tissue Dispenser B-3094
- Delta Single Handle Centerset Lavatory Faucet 520-DST
- Bobrick ClassicSeries Recessed Paper Towel Dispenser B-359
- Bobrick TrimLineSeries Recessed Paper Towel Dispenser/Waste Receptacle B-36903
- Delta Single Handle Centerset Lavatory Faucet 500-DST