Search Results "Seat Height"

• Federal Documents > Technical Assistance > Guidance on the 2010 ADA Standards for Accessible Design
  806 Transient Lodging Guest Rooms

  806 Transient Lodging Guest Rooms In the NPRM, the Department included floor plans showing examples of accessible guest rooms and bathrooms designs with mobility features to...

• State and Local Documents > Codes and Standards > 2022 California Standards
  AMUSEMENT RIDE SEAT

  [DSA-AC] A seat that is built-in or mechanically fastened to an amusement ride intended to be occupied by one or more passengers....

• Federal Documents > Standards > 36 CFR Part 1195 Standards for Accessible Medical Diagnostic Equipment
  M305.1 General

  Supports shall comply with M305.

• Federal Documents > Preamble to Standards > 36 CFR Part 1195 Standards for Accessible Medical Diagnostic Equipment - Preamble
  M305.1 General (Section-by-Section Analysis)

  This is an introductory section.

• Rulemaking Process Documents > NPRMS > 36 CFR Part 1195 Proposed Accessibility Standards for Medical Diagnostic Equipment NPRM
  M305.1 General

  Supports shall comply with M305, as applicable.

• Federal Documents > Regulations > 24 CFR Part 100—Fair Housing Accessibility Guidelines
  7(2)(b)(vii)

  or on the accessible level of a covered multistory unit, and measures a nominal 36 x 36, the shower stall must have reinforcing to allow for installation of an optional wall hung bench seat...

• Rulemaking Process Documents > NPRMS > 36 CFR Part 1195 Proposed Accessibility Standards for Medical Diagnostic Equipment NPRM - Preamble
  Head and Back Support (M301.3.3 and M302.3.3)

  Where diagnostic equipment used by patients in a supine, prone, or side-lying position, and diagnostic equipment used by patients in a seated position can be adjusted to reclined positions...

• Webinars, Videos, and Training > Official Technical Assistance
  Access Board: Transfer Type Shower Compartments
  

  This video is part of a longer animation produced by the U.S. Access Board. View the animation video in its entirety on the Access Board's website...

• Federal Documents > Standards > 36 CFR Part 1195 Standards for Accessible Medical Diagnostic Equipment
  M303.3.3.2 Cross Slope

  The cross slope of ramp runs shall not be steeper than 1:48.

• Federal Documents > Standards > 36 CFR Part 1195 Standards for Accessible Medical Diagnostic Equipment
  M303.3.3 Ramped

  Changes in level greater than ½ inch (13 mm) high shall be ramped and shall comply with M303.3.3.

• Federal Documents > Standards > 36 CFR Part 1195 Standards for Accessible Medical Diagnostic Equipment
  M302.4.1 Clearance in Base

  The base of the diagnostic equipment shall provide a clearance 39 inches (990 mm) wide minimum, 6 inches (150 mm) high minimum measured from the floor, and 36 inches (915 mm) deep...

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.8.1.2 Entry to Wheelchair Spaces on Raised Platforms

  5.8.1.2 Entry to Wheelchair Spaces on Raised Platforms.

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.8.1.2.1 Ramped Entry Slope

  5.8.1.2.1 Ramped Entry Slope. Raised platforms should have a ramp with slopes that do not exceed the following: Rise 0 to 1 ½ inches – 1:2 Slope Rise >1 ½ to 2 ½ inches – 1:8...

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.8.1.2.3 Double Ramped Entry – Edge Protection on the Platform Sides

  5.8.1.2.3 Double Ramped Entry – Edge Protection on the Platform Sides. A minimum 2 inch high edge protection must be provided on both sides of the platform for double ramped entry...

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.8.1.2.2 Single Ramped Entry – Edge Protection on the Platform and Platform Sides

  5.8.1.2.2 Single Ramped Entry – Edge Protection on the Platform and Platform Sides. A 2 inch high edge protection must be provided on the back of the platform, opposite the entry...

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.8.1.2.3 Double Ramped Entry - Edge Protection on the Platform sides Recommendations

  5.8.1.2.3 Double Ramped Entry - Edge Protection on the Platform sides Recommendations The Committee recommends a minimum two-inch high edge protection on both sides of the...

• Rulemaking Process Documents > NPRMS > 36 CFR Part 1195 Proposed Accessibility Standards for Medical Diagnostic Equipment NPRM
  M303.2.5 Surfaces

  Wheelchair space surfaces shall not slope more than 1:48 in any direction.

• Rulemaking Process Documents > NPRMS > 36 CFR Part 1195 Proposed Accessibility Standards for Medical Diagnostic Equipment NPRM
  M303.3.3.2 Cross Slope

  The cross slope of ramp runs shall not be steeper than 1:48.

• Rulemaking Process Documents > NPRMS > 36 CFR Part 1195 Proposed Accessibility Standards for Medical Diagnostic Equipment NPRM
  M303.3.3 Ramped

  Changes in level greater than ½ inch (13 mm) high shall be ramped and shall comply with M303.3.3.

• Rulemaking Process Documents > NPRMS > 36 CFR Part 1195 Proposed Accessibility Standards for Medical Diagnostic Equipment NPRM
  M303.3.3.4 Edge Protection

  Ramps with drop offs ½ inch (13 mm) or greater shall provide edge protection 2 inches (50 mm) high minimum on each side.

• Rulemaking Process Documents > NPRMS > 36 CFR Part 1195 Proposed Accessibility Standards for Medical Diagnostic Equipment NPRM
  M302.4.1 Clearance in Base

  The base of the equipment shall provide a clearance 44 inches (1120 mm) wide minimum, 6 inches (150 mm) high minimum measured from the floor, and 36 inches (915 mm) deep minimum...

• Federal Documents > Standards > 36 CFR Part 1195 Standards for Accessible Medical Diagnostic Equipment
  M303.2.5 Surfaces

  Wheelchair space surfaces shall not slope more than 1:48 in any direction.

• State and Local Documents > Codes and Standards > 2012 Florida Accessibility Code
  502.6 Identification

  502.6 Identification. Parking space identification signs shall include the International Symbol of Accessibility complying with 703.7.2.1. Signs identifying van parking spaces when...

• Federal Documents > Standards > ABA Accessibility Standard for GSA Facilities Pocket Guide
  502.6 Identification

  Parking space identification signs shall include the International Symbol of Accessibility complying with 703.7.2.1. Signs identifying van parking spaces shall contain the...