Each grab bar shall be 24 inches (610 mm) long minimum and shall be installed 24 inches (610 mm) maximum from the head end wall and 12 inches (305 mm) maximum from the control end wall....
Search Results "Assurances from Contractors"
-
11B-607.4.2.1 Back wall
-
M302.4.2 Clearance Around Base
The base of the diagnostic equipment shall provide a clearance 6 inches (150 mm) high minimum measured from the floor and 36 inches (915 mm) deep minimum measured from the edge of the examination...
-
M301.4.2 Clearance Around Base
The base of diagnostic equipment shall provide a clearance 6 inches (150 mm) high minimum measured from the floor and 36 inches (915 mm) deep minimum measured from the edge of the examination...
-
5.8.2.7 Base Support Allowance
An additional sloped region above the base support is permitted at a depth of 25 inches from the front edge of the breast platform at 1½ inches above the floor, and can extend to a height...
-
IV. Requests for Comments
While the Department has been persuaded by comments from individuals, advocacy groups, governmental entities, and at least some representatives of the movie industry that the time may be...
-
5.2.2.1 Transfer Surface Width Recommendations for M302
Rationale for final recommendation The Committee considered the dimensions for rectangular seats in roll-in showers from the 2010 Standards; and the ideal chair width recommended in Architectural...
-
Minimal protection.
Although the Department received comments urging it to eliminate the phrase "providing minimal protection" from its regulation, the Department continues to believe that the language serves...
-
225(d)(3)(B) Recovering costs
(B) Recovering costs Such regulations shall generally provide that costs caused by interstate telecommunications relay services shall be recovered from all subscribers for every interstate...
-
4.28.3(7)
(7) In general, no place in any room or space required to have a visual signal appliance shall be more than 50 ft (15 m) from the signal (in the horizontal plane)....
-
Can handrails or other elements overlap door maneuvering clearances?
However, door maneuvering clearances can be offset up to 8” from the face of the door or gate to accommodate wall thickness, casework, shelves, or other elements adjacent to doorways, including...
-
Can handrails overlap door maneuvering clearances?
However, door maneuvering clearances can be offset up to 8” from the face of the door or gate to accommodate wall thickness, casework, shelves, or other elements adjacent to doorways, including...
-
Subpart B -- General Requirements (Section-By-Section Analysis and Response to Comments)
Subpart B -- General Requirements (Section-by-Section Analysis) Subpart B includes general prohibitions restricting a public accommodation from discriminating against people with disabilities...
-
23. Extreme Weather Assistance
A passenger's request to be assisted from his or her door to a vehicle during extreme weather conditions should generally be granted so long as the driver leaving the vehicle to assist would...
-
CIRCULATION PATH
Whenever the accessible route diverges from the regular circulation path signage may be required to identify the departure from the regular route if not obvious.◼...
-
23. Extreme Weather Assistance
A passenger's request to be assisted from his or her door to a vehicle during extreme weather conditions should generally be granted so long as the driver leaving the vehicle to assist would...
-
11B-607.4.2.1 Back wall
Each grab bar shall be 24 inches (610 mm) long minimum and shall be installed 24 inches (610 mm) maximum from the head end wall and 12 inches (305 mm) maximum from the control end wall....
-
11B-809.10.7.2 Location
The centerline of the water closet shall be 17 inches (432 mm) minimum to 18 inches (457 mm) maximum from a wall or partition that is 54 inches (1372 mm) minimum in length....
-
607.4.2.1 Back Wall
Each grab bar shall be 24 inches (610 mm) long minimum and shall be installed 24 inches (610 mm) maximum from the head end wall and 12 inches (305 mm) maximum from the control end wall....
-
607.4.2.1 Back Wall
Each grab bar shall be 24 inches (610 mm) long minimum and shall be installed 24 inches (610 mm) maximum from the head end wall and 12 inches (305 mm) maximum from the control end wall....
-
Sec. 469.054(c)(3)
(3) the processing of an application for a variance from accessibility standards for a building or facility....
-
225(d)(1)(G)
(G) prohibit relay operators from intentionally altering a relayed conversation....
-
RUNNING SLOPE
(As differentiated from the definition of “Cross Slope”.)...
-
RUNNING SLOPE
(As differentiated from the definition of “Cross Slope”.)...
-
3.7 Louisville Tinseltown 19, 4400 Towne Center Drive, Louisville, Kentucky
- In Auditorium 10, the four (4) wheelchair spaces shall be relocated one row farther back in the auditorium from their current location....