Rough Wall Opening: 12" W, 18 1⁄4" H (305 x 465mm) to accept cabinet height, plus 6" (150mm) min. clearance space below towel tray; 4 1⁄2" (115mm) min. depth....
Search Results "Clearance in Base"
Filters
Commonly Searched Documents
-
Bobrick Recessed Paper Towel Dispenser B-318
-
Operable Part
Hardware-based user controls for activating, deactivating, or adjusting ICT....
-
Operable Part
Hardware-based user controls for activating, deactivating, or adjusting ICT....
-
IDEA Center
This was usually a toe in the front and the trailing edge of the wheel, backpack or edge of the power base in the rear for manual and power wheelchairs....
-
4.3.5.1 90-Degree Turn
4.3.5.1 90-Degree Turn This turning clearance is applicable for exterior and interior circulation, aisles in seating areas, ramps and other locations....
-
§ 37.105(h)
(h) Restrictions priorities based on trip purpose (if the system is demand responsive)....
-
704.5 TTY Shelf
The shelf shall be capable of accommodating a TTY and shall have 6 inches (150 mm) minimum vertical clearance above the area where the TTY is to be placed....
-
4.2.6* SIDE REACH
If the side reach is over an obstruction, the reach and clearances shall be as shown in Fig. 6(c). Figure 6 Side Reach...
-
Clear Floor Space [§309.2]
Clear Floor Space Additional clearance is required if the space is obstructed on three sides for more than half the depth to allow easier maneuvering into the space....
-
"Qualified Reader" (Section-by-Section Analysis)
Based upon the Department's investigation of complaints alleging that some entities have provided ineffective readers, the Department proposes to define "qualified reader" similarly to "...
-
Murdock Manufacturing Grab Bars
Grab bar is 1-1/2 inch (3.81 cm) diameter satin finish stainless steel and have 1-1/2 inch (3.81 cm) clearance to wall....
-
11B-704.3 Volume control telephones
Amplifiers on pay phones are located in the base or the handset or are built into the telephone. Most are operated by pressing a button or key....
-
C. Collaboration with Other Entities
Governments have complied with this obligation by using community-based treatment services to keep people with disabilities out of the criminal justice system....
-
Number of Assistive Listening Systems
In the final rule, the Board has clarified that the minimum number is to be based on each assembly area....
-
§104.33(b)(1)(ii)
(ii) are based upon adherence to procedures that satisfy the requirements of §§104.34, 104.35, and 104.36....
-
M101.4 Dimensions
The standards are based on adult dimensions and anthropometrics. Dimensions that are not stated as "maximum" or "minimum" are absolute....
-
M101.4 Dimensions
The standards are based on adult dimensions and anthropometrics. Dimensions that are not stated as “maximum” or “minimum” are absolute....
-
410.1 General
Because an accessible route requires an 80 inch (2030 mm) vertical clearance, care should be taken in selecting lifts as they may not be equally suitable for use by people using wheelchairs...
-
410.1 General
Because an accessible route requires an 80 inch (2030 mm) vertical clearance, care should be taken in selecting lifts as they may not be equally suitable for use by people using wheelchairs...
-
410.1 General
Because an accessible route requires an 80 inch (2030 mm) vertical clearance, care should be taken in selecting lifts as they may not be equally suitable for use by people using wheelchairs...
-
T503 Passenger Access Routes
In the 2016 Non-Rail Vehicle Guidelines, passenger access routes (which were referred to as “accessible circulation paths” in the proposed rule) must provide clearances sufficient to permit...
-
Furnishings and Equipment
In addition, placement of non-fixed elements can affect the accessibility of an area by encroaching into accessible routes and clearances....
-
11B-608.2.1 Transfer type shower compartments
Clearance of 36 inches (914 mm) wide minimum by 48 inches (1219 mm) long minimum measured from the control wall shall be provided....
-
11B-608.2.3 Alternate roll-in type shower compartments
FIGURE 11B-608.2.3 ALTERNATE ROLL-IN TYPE SHOWER COMPARTMENT SIZE AND CLEARANCE...
