Variation in riser height along a set of stairs can be a tripping hazard....
Search Results "Head Height"
-
Treads and Risers [4.9.2], Nosings [4.9.3]
-
11B-809.10.7.3 Reinforcement for grab bars
The grab bar reinforcement shall be 8 inches (203 mm) minimum in height. The backing shall 40 (sic) inches (1016 mm) minimum in length....
-
11B-809.10.7.3 Reinforcement for grab bars
The grab bar reinforcement shall be 8 inches (203 mm) minimum in height. The backing shall 40 (sic) inches (1016 mm) minimum in length....
-
Urinal Flush Controls
The proposed rule specified a maximum height of 44 inches (the maximum height for obstructed forward reaches)....
-
1009.2 Pool Lifts
Additional options such as armrests, head rests, seat belts, and leg support will enhance accessibility and better accommodate people with a wide range of disabilities....
-
Accessible Routes
The accessible route must comply with ADAAG provisions for the location, width (minimum of 36 inches), passing space, head room, surface, slope (maximum of 1:12 or 8.33%), changes in level...
-
Accessible Routes
Accessible route requirements in ADAAG address width (minimum of 36 inches), passing space, head room, surface, slope (maximum of 1:12 or 8.33%), changes in level, doors, egress, and areas...
-
1011.7 Outdoor Rinsing Showers
EXCEPTION: Where vandalism is a consideration, a fixed shower head located at 48 inches (1220 mm) above the ground shall be permitted in place of a hand-held shower spray unit....
-
Final Fair Housing Accessibility Guidelines
Accordingly, the Department adds the Fair Housing Accessibility Guidelines as Appendix II and the text of the preamble to these final guidelines beginning at the heading "Adoption of Final...
-
1011.7 Outdoor Rinsing Showers
EXCEPTION: Where vandalism is a consideration, a fixed shower head located at 48 in (1220 mm) above the ground shall be permitted in place of a hand-held shower spray unit....
-
1009.2 Pool Lifts
Additional options such as armrests, head rests, seat belts, and leg support will enhance accessibility and better accommodate people with a wide range of disabilities....
-
Entry Points and Seats
When play components are located on an accessible route, the height required to transfer directly to the entry point or seat of a play component has a minimum of 11 inches (280 mm) and a...
-
704.11.1 Parapet construction
The height of the parapet shall not be less than 30 inches (762 mm) above the point where the roof surface and the wall intersect....
-
1132A.4.1 Thresholds
Changes in height at interior door thresholds (e.g., floor material changes at door thresholds) shall not exceed ½ inch (12.7 mm)....
-
Guest Bathrooms
Be sure the shower head is kept in the lowest position by cleaning staff. This procedure should be included in all training....
-
Outdoor Constructed Features
The proposed rule also would have required outdoor rinsing showers to provide a fixed shower head at a lower height....
-
11B-703.5.4 Character proportions
Characters shall be selected from fonts where the width of the uppercase letter “O” is 60 percent minimum and 110 percent maximum of the height of the uppercase letter “I”....
-
11B-703.2.4 Character proportions
Characters shall be selected from fonts where the width of the uppercase letter “O” is 60 percent minimum and 110 percent maximum of the height of the uppercase letter “I”....
-
T304 Operable Parts
The technical requirements for operable parts include provisions on height, location, and operation....
-
Participants
A total of 73 participants were enrolled consisting of 56 men and 17 women, with an average age of 45 ± 15 years, body weight of 176 ± 53 lbs and a height of 67±6 in....
-
§ 38.159(c)(5) Slope
If the height of the vehicle floor from which the ramp is deployed is 3 inches (75 mm) or less above a 6 inch (150 mm) curb, a maximum slope of 1:4 is permitted; if the height of the vehicle...
-
Rakks® Wall Mounted Standards with Rakks® Brackets
Standards come with drilled and countersunk holes to accept color matched mounting screws (No. 6 x 1-1/4” Philips flat-head), which are included....
-
Evaluation of transfers
to the higher heights (Table 13). ...
-
611 Washing Machines and Clothes Dryers
Section 611 covers washing machines and clothes dryers and provides specifications for clear floor space, operable parts, and height. Comment....
