Alcoves shall be 36 inches (915 mm) wide minimum where the depth exceeds 24 inches (610 mm).
Search Results "Ground Surface"
Commonly Searched Documents
- 
    
  
  305.7.1 Forward Approach
  
 - 
    
  
  240.2 Play Components
  
Where provided, play components shall comply with 240.2.
 - 
    
  
  240.2 Play Components
  
240.2 Play Components. Where provided, play components shall comply with 240.2.
 - 
    
  
  11B-305.7.1 Forward approach
  
Alcoves shall be 36 inches (914 mm) wide minimum where the depth exceeds 24 inches (610 mm). FIGURE 11B-305.7.1 MANEUVERING CLEARANCE IN AN ALCOVE, FORWARD APPROACH
 - 
    
  
  305.7.2 Parallel Approach
  
305.7.2 Parallel Approach. Alcoves shall be 60 inches (1525 mm) wide minimum where the depth exceeds 15 inches (380 mm). Figure 305.7.2 Maneuvering Clearance in an Alcove,...
 - 
    
  
  305.7.1 Forward Approach
  
Alcoves shall be 36 inches (915 mm)wide minimum where the depth exceeds 24 inches (610 mm).
 - 
    
  
  305.7.2 Parallel Approach
  
Alcoves shall be 60 inches (1525 mm) wide minimum where the depth exceeds 15 inches (380 mm).
 - 
    
  
  11B-305.7.1 Forward approach
  
Alcoves shall be 36 inches (914 mm) wide minimum where the depth exceeds 24 inches (610 mm).
 - 
    
  
  11B-305.7.2 Parallel approach
  
Alcoves shall be 60 inches (1524 mm) wide minimum where the depth exceeds 15 inches (381 mm).
 - 
    
  
  11B-240.2 Play components
  
Where provided, play components shall comply with Section 11B-240.2.
 - 
    
  
  11B-305.7.1 Forward approach
  
Alcoves shall be 36 inches (914 mm) wide minimum where the depth exceeds 24 inches (610 mm).
 - 
    
  
  11B-305.7.2 Parallel approach
  
Alcoves shall be 60 inches (1524 mm) wide minimum where the depth exceeds 15 inches (381 mm).
 - 
    
  
  11B-240.2 Play components
  
Where provided, play components shall comply with Section 11B-240.2.
 - 
    
  
  4.7.5 Openings
  
Openings in surface of the clear floor or ground spaces required by section 2.0 shall not allow passage of a sphere more than 1/2 inch (13 mm) in diameter....
 - Smith System Husky Clover Activity Table
 - 
    
  
  Resting Intervals on Trails
  
, fiberglass, or other manufactured material), it’s more difficult to ensure drainage on natural or gravel surfaces....
 - 
    
  
  TEST NO. 2 – SITE ANALYSIS TEST
  
In no case shall less than 20 percent of the ground floor dwelling units be on an accessible route and comply with the provisions of Division IV. 3. ...
 - 
    
  
  Cross Slope
  
Comment. Comments indicated that specifications for cross slope (1:48 maximum) are not referenced in the curb ramp section. Response. In the final rule, the Board has clarified...
 - 
    
  
  1011.4.1 Height
  
The tops of picnic tables shall comply with 902.3.
 - 
    
  
  Medical Diagnostic Equipment Accessibility Standards Sub-Committee Recommendations Imaging Equipment
  
Accessibility Standards for Medical Diagnostic Equipment Medical Diagnostic Equipment Accessibility Standards Sub-Committee Recommendations - Imaging Equipment Final...
 - 
    
  
  Handrails
  
...are there handrails on both sides of the stair at a uniform height of 34"-38" above the front edge of the step? [ADA Stds. 4.9] Yes __ No __ N/A __ Comments:...
 - 
    
  
  A5.  Accessible Parking Spaces
  
A5. Are all accessible parking spaces, including the access aisle, relatively level (1:50 or 2%) in all directions? [ADA Stds 4.6.3] If No: Look for a nearby area that is relatively...
 - 
    
  
  1011.4.1 Height
  
The tops of picnic tables shall comply with 902.3.
 - 
    
  
  1.2.3 Landings
  
1.2.3 Landings. Both measurements of ramp landings as described in Section 1.1.15 should not exceed a plus tolerance of 0.5%.