In no case shall less than 20 percent of the ground floor dwelling units be on an accessible route and comply with the provisions of Division IV. 3. ...
Search Results "Ground Surface"
Commonly Searched Documents
- 
    
  
  TEST NO. 2 – SITE ANALYSIS TEST
  
 - 
    
  
  Cross Slope
  
Where floating piers are grounded out due to low water conditions, slope requirements would not apply....
 - 
    
  
  11B-233.3.1.2.6.4 Test number three, unusual characteristics test
  
Unusual characteristics include sites located in a state or federally designated floodplain or coastal high-hazard areas and sites subject to other similar requirements of law or...
 - National Floor Safety Institute (NFSI)
 - 
    
  
  5.4.4.1 Transfer Support Distance from Transfer Surface Recommendation for Stretchers
  
surface on the opposite side of the transfer....
 - 
    
  
  5.1.2 Transfer Surface High Height Recommendations for M301 and M302
  
5.1.2 Transfer Surface High Height Recommendations for M301 and M302 The Committee recommends an adjustable height range with an upper height measuring at least 25 inches....
 - 
    
  
  1007.3.2 Golf Club Reach Range Area
  
All areas within holes where golf balls rest shall be within 36 inches (915 mm) maximum of a clear floor or ground space 36 inches (915 mm) wide minimum and 48 inches (1220 mm) long minimum...
 - 
    
  
  11B-1007.3.2 Golf club reach range area
  
All areas within holes where golf balls rest shall be within 36 inches (914 mm) maximum of a clear floor or ground space 36 inches (914 mm) wide minimum and 48 inches (1219 mm) long minimum...
 - 
    
  
  11B-1007.3.2 Golf club reach range area
  
All areas within holes where golf balls rest shall be within 36 inches (914 mm) maximum of a clear floor or ground space 36 inches (914 mm) wide minimum and 48 inches (1219 mm) long minimum...
 - Diversified Woodcrafts ADA Instructor's Desk 1214K-L-ADA
 - Smith System Trespa Planner Science Table 30″ Deep 11288
 - 
    
  
  5.2.1.4 Transfer Surface Size for Imaging Equipment
  
5.2.1.4 Transfer Surface Size for Imaging Equipment. The transfer surface should be 28 inches wide minimum and 21 inches deep minimum....
 - 
    
  
  1133A.4, Item 2
  
A minimum linear length of 30 inches (762 mm) of countertop shall be provided for a work surface....
 - 
    
  
  1133A.4, Item 2
  
A minimum linear length of 30 inches (762 mm) of countertop shall be provided for a work surface....
 - 
    
  
  1007.3.2 Golf Club Reach Range Area
  
All areas within holes where golf balls rest shall be within 36 inches (915 mm) maximum of a clear floor or ground space 36 inches (915 mm) wide minimum and 48 inches (1220 mm) long minimum...
 - Behavioral Safety Products #BF920 Suicide Resistant Attenda Desk
 - Varidesk Pro Desk Series: the Pro Desk 60
 - Pro Desk Series Description - VARIDESK
 - Humanscale's Float Height-Adjustable Table
 - Steelcase Ology Series height-adjustable tables
 - 
    
  
  § 38.25(a) Slip resistance
  
All aisles, steps, floor areas where people walk and floors in securement locations shall have slip-resistant surfaces....
 - 
    
  
  11B-1007.3.2 Golf club reach range area
  
All areas within holes where golf balls rest shall be within 36 inches (914 mm) maximum of a clear floor or ground space 36 inches (914 mm) wide minimum and 48 inches (1219 mm) long minimum...
 - 
    
  
  What kinds of treatments constitute maintenance rather than an alteration?
  
Treatments that serve solely to seal and protect the road surface, improve friction, and control splash and spray are considered to be maintenance because they do not significantly affect...
 - GameTime Bongos