Failing or refusing to make alterations to QuikTrip Stores in full compliance with 42 U.S.C. § 12183(a)(2), 28 C.F.R. §§ 36.402 - 36.406, and the ADA Standards; d....
Search Results "Altered Element"
-
II. GENERAL NONDISCRIMINATION REQUIREMENTS
-
§ 35.150 Existing facilities
§ 35.150 Existing facilities. * * * * *
-
8. Amend § 35.150 as follows:
8. Amend § 35.150 as follows: a. Redesignate paragraph (b)(2) as paragraph (b)(3); b. Add the words "or acquisition" after the word "redesign" in the first sentence of...
-
§35.150 Existing facilities
§35.150 Existing facilities.
-
4.1.6(1)(f)
(f) If an escalator or stair is planned or installed where none existed previously and major structural modifications are necessary for such installation, then a means of accessible...
-
404.2.3 Clear Width
In alterations, a projection of 5/8 inch (16 mm) maximum into the required clear width shall be permitted for the latch side stop. 2....
-
404.2.3 Doorways - Clear Width
In alterations, a projection of 5/8 inch (16 mm) maximum into the required clear width shall be permitted for the latch side stop. 2....
-
11B-404.2.3 Clear width
In alterations, a projection of 5/8 inch (15.9 mm) maximum into the required clear width shall be permitted for the latch side stop. 2....
-
11B-404.2.3 Clear width
Exceptions: In alterations, a projection of 5/8 inch (15.9 mm) maximum into the required clear width shall be permitted for the latch side stop....
-
Example 1: With Cooking Facilities
The following is a general analysis of the compliance requirements for these elements. Storage: Must comply with 804.5 and 811....
-
Utility Sinks
A utility sink is deeper than a standard restroom basin or kitchen sink and can be used to clean large pots or equipment. Usually, utility sinks are provided only in highly developed...
-
Verify Rough Plumbing
VERIFY ROUGH PLUMBING – remember finish material thicknesses! Location of toilet flanges from...
-
Verify Rough Plumbing
VERIFY ROUGH PLUMBING – remember finish material thicknesses! Location of toilet flanges from...
-
§ 38.123(a)(1)
(1) The minimum clear floor area shall be 35 inches by 60 inches. Permanently installed fixtures may overlap this area a maximum of 6 inches, if the lowest portion of the fixture is...
-
Accessible Path of Travel
When alterations are made to a primary function area, an accessible path of travel to the area must be provided....
-
1. My business does not need to be compliant because the building is old and therefore is grandfathered.
If your facility was built or had any alterations made to it since January 26, 1992 (under the ADA) or was built or had any alterations made to it since 1970 (under California law), there...
-
404.2.3 Clear Width
In alterations, a projection of 5/8 inch (16 mm) maximum into the required clear width shall be permitted for the latch side stop. 2....
-
11B-404.2.3 Clear width
In alterations, a projection of 5/8 inch (15.9 mm) maximum into the required clear width shall be permitted for the latch side stop. 2. ...
-
404.2.3 Clear Width
In alterations, a projection of 5/8 inch (16 mm) maximum into the required clear width shall be permitted for the latch side stop. 2....
-
§27.7(e) Reasonable accommodations
procedures when such accommodations are necessary to avoid discrimination on the basis of disability unless the recipient can demonstrate that making the accommodations would fundamentally alter...
-
11B-703.1.1 Plan review and inspection
Signs as specified in Section 11B-703, or in other sections of this code, when included in the construction of new buildings or facilities, or when included, altered or replaced due to additions...
-
11B-703.1.1 Plan review and inspection
Signs as specified in Section 11B-703, or in other sections of this code, when included in the construction of new buildings or facilities, or when included, altered or replaced due to additions...
-
B. 2004 ADA and ABA Accessibility Guidelines
Until HUD adopts a new accessibility standard, HUD recipients who undertake alterations or new construction of a project may continue to utilize UFAS and HUD’s Section 504 or ABA regulations...