Signs as specified in Section 11B-703, or in other sections of this code, when included in the construction of new buildings or facilities, or when included, altered or replaced due to additions...
Search Results "Altered Element"
-
11B-703.1.1 Plan review and inspection
-
Example 1: With Cooking Facilities
The following is a general analysis of the compliance requirements for these elements. Storage: Must comply with 804.5 and 811....
-
Utility Sinks
A utility sink is deeper than a standard restroom basin or kitchen sink and can be used to clean large pots or equipment. Usually, utility sinks are provided only in highly developed...
-
Verify Rough Plumbing
VERIFY ROUGH PLUMBING – remember finish material thicknesses! Location of toilet flanges from...
-
Verify Rough Plumbing
VERIFY ROUGH PLUMBING – remember finish material thicknesses! Location of toilet flanges from...
-
§ 38.123(a)(1)
(1) The minimum clear floor area shall be 35 inches by 60 inches. Permanently installed fixtures may overlap this area a maximum of 6 inches, if the lowest portion of the fixture is...
-
206.2.3 Multi-Story Buildings and Facilities
Spaces and elements located on a level not required to be served by an accessible route must fully comply with this document....
-
DEFINITION: MOBILITY DEVICES
All such devices must be permitted in any area that pedestrians use unless it would result in a fundamental alteration, is a direct threat, or creates a safety hazard....
-
11B-213.2 Toilet rooms and bathing rooms
In alterations where it is technically infeasible to comply with Section 11B-603, altering existing toilet or bathing rooms shall not be required where a single unisex toilet room or bathing...
-
4.1.6(4)(f)
(i) In alterations where it is structurally impracticable to disperse seating throughout the assembly area, seating may be located in collected areas as structurally feasible....
-
Sec.36.308(a)(3)
(3) The requirements of paragraph (a) of this section shall not be interpreted to exceed the standards for alterations in subpart D of this part....
- Murdock Manufacturing Waterless Campground Urinal, Front Mount
- Willoughby Industries WAW-2333 AquaWave® Three Station Solid Surface Lavatory System
- American Standard Decorum 0.125 gpf Urinal System with Selectronic Battery-Powered Flush Valve
- Willoughby Industries WAW-2322 AquaWave® Two Station Solid Surface Lavatory System
- American Standard Acrylic Seated Safety Shower
- Kohler Primary Elongated Toilet Bowl with Seat
- Willoughby Industries CEL-Multi-Station Lavatory Series
- Willoughby Industries ASETW1490FM Ligature-Resistant Floor Mounted Blowout Series Water Closet
- American Standard Jetbrook Urinal
- Willoughby Industries WAW-2311 AquaWave® Single Station Solid Surface Lavatory System
- Whitehall Mfg. Ligature Resistant Bariatric Stainless Steel Basin
-
11B-213.2 Toilet rooms and bathing rooms
In alterations where it is technically infeasible to comply with Section 11B-603, altering existing toilet or bathing rooms shall not be required where a single unisex (single-user or family...
-
11B-213.2 Toilet rooms and bathing rooms
In alterations where it is technically infeasible to comply with Section 11B-603, altering existing toilet or bathing rooms shall not be required where a single unisex (single-user or family...