ADA phone Direction indicators in cab Automatic Sliding Doors Arrival gongs in cab Stainless Steel Handrail Exit Hatch In cab fan...
Search Results "Horizontal Exit"
Filters
Commonly Searched Documents
-
Federal Elevator 360 Passenger Elevator
-
Open Sesame Remote Controlled Low-Voltage Door System
Complete Independence at the touch of a button, the Open Sesame automatic door opener gives complete independence to enter and exit a residential or public / light commercial door (which...
-
TownSteel ED1300 Grade 1 Concealed Vertical Rod Panic Device
The ED1000 Series Exit Devices and Trims are designed for new or retrofit installation of Von Duprin 98/99 Series. ED1300 is ANSI Certified Grade 1 and UL listed for Panic Hardware....
-
1118B.3
Changes in level between 1/4 inch (6.4 mm) and 1/2 inch (12.7 mm) shall be beveled with a slope no greater than one unit vertical in 2 units horizontal (50-percent slope) [see Figure 11B...
-
Executive summary
Yet, there is no evidence concerning height differences, horizontal distance, and space needed next to the target surface so it can be accessible by a majority of WMD users. ...
-
F - number system
The FL defines the relative conformity of the floor surface to a horizontal plane as measured over a 10 - foot (3.05 m) distance....
-
1134A.5 Bathtubs
Grab bar backing shall be installed horizontally to permit the installation of a 48-inch (1219 mm) grab bar with each end a maximum of 6 inches (152.4 mm) from the end walls of the bathtub...
-
Kawneer North America AA™250/425 Thermal Entrances
8" typical wall thickness Dual welded corner construction Single acting Offset pivots, butt hinges or continuous geared hinge Surface mounted or concealed closers MS locks or exit...
-
Evaluation of transfers
There is a general recommendation regarding the height of a horizontal grab bar (parallel to the floor) to be between 33”-36” (83.8-91.4cm) for water stalls, water closets, bathtubs, and...
-
A. Purpose and Legal Authority
clinics, emergency rooms, hospitals, and other medical settings, is accessible to, and usable by, individuals with accessibility needs, and shall allow independent entry to, use of, and exit...
-
1127B.1
Site development and grading shall be designed to provide access to all entrances and exterior ground floor exits, and access to normal paths of travel, and where necessary to provide access...
-
F105.2.3 ASTM
adjacent to a play structure or play equipment designed for unrestricted circulation around the equipment and on whose surface it is predicted that a user would land when falling from or exiting...
-
105.2.3 ASTM
adjacent to a play structure or play equipment designed for unrestricted circulation around the equipment and on whose surface it is predicted that a user would land when falling from or exiting...
-
105.2.3 ASTM
adjacent to a play structure or play equipment designed for unrestricted circulation around the equipment and on whose surface it is predicted that a user would land when falling from or exiting...
-
T402 Ramps and Bridgeplates
This accommodates wheelchair users’ need to turn as they enter and exit the ramp and reduces the likelihood that passersby will trip on the barrier....
-
Clear Width of Circulation Paths and Maneuvering Clearances at Wheelchair Spaces
approach in the existing guidelines by requiring “sufficient clearances” for passengers who use wheelchairs to move between accessible doorways and wheelchair spaces, and to enter and exit...
-
Eliason Corporation FP-ALU5R Heavy Duty Aluminum Mid-Panel Door
Notice: Exit device trims and levers may overlap the edge of the glazing area. Green Guard: YES, Certified for Low Emitting Products for Children and Schools and Indoor Air Quality....
-
Cal-Royal JHIL Series Interconnected Lockset
Specifications GENERAL SPECIFICATIONS - Simultaneous retraction on both latch and deadbolts from inside by turning the lever in a panic-proof exit situation....
-
5.8.2.7 Base Support Allowance Recommendation
The green dots in the scatter plot illustrations represent observed values for footrest height (on the vertical axis), and footrest depth (on the horizontal axis) measured for manual wheelchair...
-
M301.2.1 Transfer Surface Height
X-Ray tables are also typically rated for patients in excess of 400 lbs, but are wider than those used with equipment with bores and in many cases are able to move horizontally in two directions...
-
221.2.3.2 Vertical Dispersion
arenas, and grandstands, wheelchair spaces and companion seats are dispersed to all levels that include seating served by an accessible route; (2) Assembly areas that are required to horizontally...
-
Table 2: Summary of Department of Transportation Survey
±1/2" (±13 mm) 15 Horizontal placement of poles, controls, signs, etc. 0 12 in. 2.62 in....
-
Section 810.5.3
from the former §10.3.1 (9) (Exception 2), which provides that “In light rail, commuter rail, and intercity rail systems where it is not operationally or structurally feasible to meet the horizontal...
-
Work Areas (Preamble, Section-by-Section Analysis)
proposed paragraphs would have required that areas that will be used only by employees as work stations be constructed so that individuals with disabilities could approach, enter, and exit...
