Floor surfaces in elevator cars shall comply with 302 and 303....
Search Results "Transfer Surface Height"
Filters
Commonly Searched Documents
-
408.4.2 Floor Surfaces
-
408.4.2 Floor Surfaces
Floor surfaces in elevator cars shall comply with 302 and 303....
-
Inpro Corporation JointMaster® 806 Series Floor Expansion Joint Covers
Designed for uneven slab conditions Pre-drilled counter-sunk holes for easy installation Applicable for existing conditions, additions and new construction Anti-slip surface...
-
606.5 Exposed Pipes and Surfaces
There shall be no sharp or abrasive surfaces under lavatories and sinks...
-
Other international standards
Australian NATSPEC Reference Volume 1: Building Works, Concrete Finishes Section Three classes of surface finish based on using a straightedge method of testing: Class A...
-
III. Results of the Study
Table 10 shows the surface materials recommended by region and surface composition....
-
M305.2.7 Clearance
Clearance between the transfer support gripping surface and adjacent surfaces or obstructions shall be 1 ½ inches (38 mm) minimum....
-
804.3 Kitchen Work Surface
In residential dwelling units required to comply with 809, at least one 30 inches (760 mm) wide minimum section of counter shall provide a kitchen work surface that complies with 804.3....
-
804.3 Kitchen Work Surface
In residential dwelling units required to comply with 809, at least one 30 inches (760 mm) wide minimum section of counter shall provide a kitchen work surface that complies with 804.3....
-
4.30.6 Mounting Location and Height
4.30.6 Mounting Location and Height. Where permanent identification is provided for rooms and spaces, signs shall be installed on the wall adjacent to the latch side of the door....
-
Observations and Results
After playing for several minutes on each surface, the children were asked to stand on the surface they preferred....
-
Spas
Spas Spas must provide at least one accessible means of entry, which can be a pool lift, transfer wall, or transfer system. ...
-
606.5 Exposed Pipes and Surfaces
There shall be no sharp or abrasive surfaces under lavatories and sinks. [ECTCR UFAS 4.19.4, 4.24.6, 4.34.6.5(8)]...
-
M305.2.7 Clearance (Section-by-Section Analysis)
surface....
-
Figure 302.3 Elongated Openings in Floor or Ground Surfaces – Drawing from the U.S. Access Board
-
1.1.3
1.1.3 A maximum overall design running slope for exterior accessible surfaces (other than ramps), such as sidewalks, of 4% (approximately 1:25) is recommended....
-
1005.2.1 Height
At least 25 percent of the railings, guards, or handrails shall be 34 inches (865 mm) maximum above the ground or deck surface....
-
1005.2.1 Height
At least 25 percent of the railings, guards, or handrails shall be 34 inches (865 mm) maximum above the ground or deck surface....
-
Museum Gift Shop
The 42" height of the main cashier counter and the 42 1/2" height of the second cashier counter exceed the maximum 36" allowable height above the finished floor....
-
17. Can broken or older ground level play components be replaced without changing the surface?
Can broken or older ground level play components be replaced without changing the surface? Yes....
-
11B-606.5 Exposed pipes and surfaces
11B-606.5 Exposed pipes and surfaces. Water supply and drain pipes under lavatories and sinks shall be insulated or otherwise configured to protect against contact....
-
Data Collection Procedures
study surfaces. ...
-
Firmness
The degree of surface resistance to deformation, especially by indentation or the movement of objects (U.S. Access Board, 2007)....
