Where dining surfaces are provided for the consumption of food or drink, at least 5 percent of the seating spaces and standing spaces at the dining surfaces shall comply with 902....
Search Results "Ground Surface"
Filters
Commonly Searched Documents
-
226.1 General
-
Don-Jo Mfg., Inc. Vertical Rod Protector 83
Number 83 Description Latch Bolt...
-
Architectural Builders Hardware 1811 Vertical Rod Protectors
Assist in accessibility conformance. Use in hospitals and schools, etc. 18 GA. #304 Stainless Steel #4 satin finish. Installs with #6 x 3/4" screws directly into the...
-
Rockwood Manufacturing Vertical Rod Cover BFRC12
The vertical rod cover (BFRC) is a sturdy channel made of .050" stainless steel (other finishes available) designed to fit over the vertical rod, protecting it from damage caused by...
-
Don-Jo Mfg., Inc. Vertical Rod Protector 85
Product Specifications Number 85 Description Rod...
-
Don-Jo Mfg., Inc. Vertical Rod Protector 81
Product Specifications Number 81 Description Latch Bolt...
-
Rockwood Manufacturing Company BFRC24 Vertical Rod Cover
The vertical rod cover (BFRC) is a sturdy channel made of .050" stainless steel (other finishes available) designed to fit over the vertical rod, protecting it from damage caused by...
-
Sargent LS8600 Low Profile Center and Top Latch Concealed Vertical Rods Exit Device
SARGENT manufactures a fine line of exit devices providing the best combination of strength, durability, simplicity, aesthetics and innovation. The LS8600 has security of a stainless...
-
5.2.1.3 Transfer Surface Size Recommendations for Stretchers (M301)
5.2.1.3 Transfer Surface Size Recommendations for Stretchers (M301) The Committee recommends a minimum transfer surface size of 28 inches wide by 17 inches deep for stretchers located...
-
11B-226.1 General
Where dining surfaces are provided for the consumption of food or drink, at least 5 percent of the seating spaces and standing spaces at the dining surfaces shall comply with Section 11B...
-
11B-226.1 General
Where dining surfaces are provided for the consumption of food or drink, at least 5 percent of the seating spaces and standing spaces at the dining surfaces shall comply with Section 11B...
-
11B-226.1 General
Where dining surfaces are provided for the consumption of food or drink, at least 5 percent of the seating spaces and standing spaces at the dining surfaces shall comply with Section 11B...
-
National Council on Independent Living
National Council on Independent Living MDE Minority Paper for a 17 inch low Transfer Surface Height Submitted to the U.S....
-
5.1 Transfer Surface Height Recommendations
5.1 Transfer Surface Height Recommendations Description: The transfer height is set above the finished floor surface to permit transfers form mobility devices onto the transfer surface...
-
5.1.3 Transfer Surface Low Height
5.1.3 Transfer Surface Low Height. No agreement on final low height...
-
§ 35.150(b)(4)(i)
(i) In addition to the provisions of section 240.2.1 of the proposed standards, where an existing play area provides elevated play components, an additional number of ground level play components...
-
Accessible Route to Play Components
Section 206.2.17 of the 2010 Standards provides scoping requirements for accessible routes to ground level and elevated play components and to soft contained play structures....
-
M302.2.1 Adjustability (Section-by-Section Analysis)
The MDE NPRM proposed a transfer surface height range for diagnostic equipment used by patients in a seated position of 17 inches minimum and 19 inches maximum....
-
1013.3 Height
From the adjacent walking surfaces; 2. On stairs, from the line connecting the leading edges of the tread nosings; and 3. On ramps, from the ramp surface at the guard....
-
1015.3 Height
Required guards shall not be less than 42 inches (1067 mm) high, measured vertically as follows: From the adjacent walking surfaces....
-
11B-102 Dimensions for adults and children
this chapter includes technical requirements based on children's dimensions and anthropometries for drinking fountains, water closets, toilet compartments, lavatories and sinks, dining surfaces...
-
F102 Dimensions for Adults and Children
this document includes technical requirements based on children's dimensions and anthropometrics for drinking fountains, water closets, toilet compartments, lavatories and sinks, dining surfaces...
