The end of the “L” shall be 22 inches (559 mm) minimum and 23 inches (584 mm) maximum from the main seat wall....
Search Results "End of Row Compartment"
-
11B-610.3.2 L-shaped seats
-
Revolving Doors or Turnstiles
While automated revolving doors, if large enough, may be usable by people with disabilities, certain questions remain about the appropriate maximum speed, minimum diameter, compartment size...
-
H. Men's Spa and Fitness Center Locker Room
(2) Defendants will convert the accessible shower compartment in the Men's Spa Dressing Room and Men's Fitness Center Locker room to a compliant shower including compliant controls,...
-
Toilet and Bathing Rooms
A commenter recommended that in shower compartments rectangular seats as provided in section 610.3.1 of the 2010 Standards should not be permitted as a substitute for L-shaped seats as provided...
-
Scope: ADA Standard Section 301.1
Sections 301.1 of the ADA Standards covers scoping requirements for Chapter 3 and the Building Blocks of the ADA Standards.
-
Slope: ADA Standard Section 403.3
Section 403.3 covers the current ADA Standards for the slope of walking surfaces that are part of an accessible route.
-
Figures: ADA Standard Section 104.3
Section 104.3 of the ADA Standards covers the most current information on the use of figures throughout the ADA Standards.
-
General: ADA Standard Section 203.1
Section 203.1 of the ADA Standards covers information on scoping requirements of general exceptions in the most current ADA Standards.
-
Do access aisle borders (in blue) have to be painted on all four sides to be considered compliant?
I would also say that both of the "end" lines would/could be within the required length. ...
-
5.3.1 Permitted Obstructions to Transfer Sides for M301 and M302
The 2010 Standards provide a gap of 3 inches between the edge of a shower seat and the shower compartment entry, and the gap does not appear to interfere with transferring onto and off the...
-
11B-609.3 Spacing
The space between the grab bar and projecting objects below and at the ends shall be 1½ inches (38 mm) minimum....
-
11B-609.3 Spacing
The space between the grab bar and projecting objects below and at the ends shall be 1½ inches (38 mm) minimum....
-
410.6 Doors and Gates
End doors and gates shall provide a clear width 32 inches (815 mm) minimum. Side doors and gates shall provide a clear width 42 inches (1065 mm) minimum....
-
11B-410.6 Doors and gates
End doors and gates shall provide a clear width 32 inches (813 mm) minimum. Side doors and gates shall provide a clear width 42 inches (1067 mm) minimum....
-
Handrail Extensions
Handrail Extensions ADAAG addresses handrail height, diameter, and extensions provided to the end of the gangway....
-
610.3.2 L-Shaped Seats
The end of the "L" shall be 22 inches (560 mm) minimum and 23 inches maximum (585 mm) from the main seat wall....
-
5.2.1.3 Transfer Surface Size Recommendations for Stretchers (M301)
The patient would not use the short end as the point of entry because it would require the patient to slide a long distance to lie on the stretcher....
-
Curb Ramps and Blended Transitions (R309.4) (Section-by-Section Analysis)
Parking spaces at the end of block face can be served by curb ramps or blended transitions at the pedestrian street crossing....
-
11B-604.5.1 Side wall
wall grab bar shall be 42 inches (1067 mm) long minimum, located 12 inches (305 mm) maximum from the rear wall and extending 54 inches (1372 mm) minimum from the rear wall with the front end...
-
Section 1193.23 Product design, development and evaluation
At this end of the evaluation spectrum, only one hour of professional time is projected to be required, for an estimated cost of $80....
-
4.Information, documentation, and training
Such information and documentation includes user guides, installation guides for end-user installable devices, and product support communications, regarding both the product in general and...
-
206.7 Platform Lifts, F206.7 Platform Lifts
Amendatory Language For the reasons stated in the preamble, we amend 36 CFR part 1191 as follows: In 206.7, adding a new sentence at the end of the section to read as follows: 206.7...
-
3.6.2. Device Replacement
To account for the ongoing costs associated with the replacement of devices prior to the end of their lifespan and the replacement of these devices at the end of their lifespan, the primary...