internal corner clips 1" x 4" door frame 0.125 nominal wall thickness, door and frame Three way adjustable butt hinges Polyamide thermal break Double row...
Search Results "End of Row Compartment"
-
Kawneer North America 2000T Terrace Doors
-
Acceleration
For the initial distance traveled, 0 to 12.2 m (0 to 40 ft), hand cycles, manual wheelchairs, and Segways had acceleration rates slower than the lower end of the range used by AASHTO (i.e...
-
Pilot Rock AT Series Traditional A-Frame Picnic Table With Steel Braces - Using Recycled Plastic
These picnic tables have 8 ft. tops which extend 1 foot beyond each end of the 6 ft. seats. ...
-
Landscape Forms Inc. Parallel 42 Bench Collection
The straight end unit cannot be placed end-to-end with a angled unit...
-
Bobrick Double Robe Hook B-6727
Contoured 4" (100mm) wide bar forms hook at each end. Flange is 2" x 2" (50 x 50mm). Projects 2 5⁄16" (60mm) from wall....
-
The Smith-Kettlewell Eye Research Institute
To this end, we will maintain an independent research institute which maximizes individual responsibility and innovation, which promotes a balance of laboratory, clinical and rehabilitation...
-
11B-216.1 General
Building directories, menus, seat and row designations in assembly areas, occupant names, building addresses, and company names and logos shall not be required to comply with Section 11B...
-
TICKETING
identified; Tickets for accessible seating must be available at all price levels; A wheelchair user may purchase up to three companion seats that are contiguous and in the same row...
-
11B-216.1 General
Building directories, menus, seat and row designations in assembly areas, occupant names, building addresses, and company names and logos shall not be required to comply with Section 11B...
-
28 CFR Part 36, Appendix C: Guidance on ADA Regulation on Nondiscrimination on the Basis of Disability by Public Accommodations and in Commercial Facilities (2010 ADA Title III Regulations: 1991 Preamble and Section-by-Section Analysis)
nondiscrimination on the basis of disability by public accommodations and in commercial facilities beginning at the heading "Section-by-Section Analysis and Response to Comments'' and ending...
-
M303.2.4.2.2 Height
Wheelchair spaces shall include toe clearance 9 inches (230 mm) high minimum above the floor measured to a depth of 6 inches (150 mm) maximum measured from the toe end of the wheelchair...
-
M305.3.2 Height (Section-by-Section Analysis)
For vertical supports, the MDE NPRM proposed that the bottom end of the support be 34 inches high minimum and 37 inches high maximum above the standing surface....
-
M304.2.2 Standing Supports (Section-by-Section Analysis)
In addition, the Access Board has added a new exception for diagnostic equipment with entry and exit that permits pass-through from one end to another to provide one standing support provided...
-
28 CFR Part 35, Appendix B: 1991 ADA Title II Regulations Preamble and Section-by-Section Analysis
of the preamble to the final regulation on nondiscrimination on the basis of disability in State and local government services beginning at the heading “Section-by-Section Analysis” and ending...
-
What does the Voting Rights Act do?
In recent times, courts have applied the Act to end race discrimination in the method of electing state and local legislative bodies and in the choosing of poll officials....
-
Issue 24: What are the long-term and short-term targets for guidance?
I think as we near the end of our discussion, I would like to hear things rapidly go on a list....
-
§8.1(a)
(a) The purpose of this part is to effectuate section 504 of the Rehabilitation Act of 1973, as amended (29 U.S.C 794), to the end that no otherwise qualified individual with handicaps in...
-
20.1 Q. If a covered multifamily dwelling has an individual, private garage which is attached to and serves only that dwelling, does the garage have to be accessible in terms of width and length?
14(c) addresses parking garages where there are several garages or stalls located together, either in a separate, detached building, or in a central area of the building, such as at one end...
-
A.2.i. - What does Section 508 require?
508 generally requires Federal agencies to ensure that, when developing, procuring, maintaining, or using electronic and information technology, they take into account the needs of all end...
-
Grab Bars [4.16.4]
It must be 36 inches long minimum, installed with one end space a maximum of 6 inches from the side wall....
-
Height of Tables or Counters [4.32.4]
A height at the lower end of this range is generally preferable for surfaces used for extended periods of time (study carrels, dining counters, kitchen counters in dwelling units) as opposed...
