restoration, resurfacing of circulation paths or vehicular ways, changes or rearrangement of the structural parts or elements, and changes or rearrangement in the plan configuration of walls and full-height...
Search Results "Full Length Mirror"
Commonly Searched Documents
-
[A] ALTERATION
- Omnia Industries Inc. Interior Modern Lever Latchset - Stainless Steel No.47
-
(1) Transfer Surface Location for Diagnostic Equipment Used in the Supine, Prone, or Side-lying Position
Additionally, a transfer approach at the foot location may not be practical for many people with disabilities who would have to move themselves or be moved across a significant length of...
-
105.2.2 ASME
The enclosure walls not used for entry or exit are required to have a grab bar the full length of the wall on platform lifts....
-
1118B.4
One full unobstructed side of the clear floor or ground space for a wheelchair shall adjoin or overlap an accessible route or adjoin another wheelchair clear floor space....
-
105.2.2 ASME
The enclosure walls not used for entry or exit are required to have a grab bar the full length of the wall on platform lifts....
-
3.3.2 Experienced Clinicians
These deliberations will include discussions about the position (horizontal, angled, or vertical), length, gripping shape, and distance above and from the transfer surface....
-
11B-604.5.2 Rear wall
The rear grab bar shall be permitted to be 24 inches (610 mm) long minimum, centered on the water closet, where wall space does not permit a length of 36 inches (914 mm) minimum due to the...
-
Appendix 3 - Comparison of US Standards to IDEA Center Research
Unoccupied Width 660 77 609 475 712 Unoccupied Length...
-
Top Landings
Curb ramps must be connected by an accessible route which, in effect, requires space at least 36 inches in length at the top of curb ramps....
-
Sharing an Access Aisle
Requirements for access aisles in section 502.3 address width, length, marking, and location. Two spaces are permitted to share an access aisle....
-
Elevated Accessible Routes
A typical elevated accessible route might include the following: 36-inch (915 mm) clear width 32-inch (815 mm) narrowed width permitted for 24-inch (610 mm) length to accommodate...
-
Teeing Grounds
A rectangular area usually two club-lengths in depth, the teeing ground’s borders are defined by the outside limits of two “tee-markers.”...
-
Handrails [4.8.5]
Handrails are required on both sides for ramps with a rise more than 6 inches or a horizontal length more than 72 inches....
-
2.2.4 Maneuverability
2.2.4 Maneuverability WhMD users were video recorded while completing the following tasks: • 90-degree turn, • 180-degree turn with no restrictions on length of the maneuver,...
- Tork Image Design™ Matic® Hand Towel Roll Dispenser with Intuition® Sensor
-
Re: When is a Curb Ramp a Ramp?
I might be wrong here but 1:17 is close to 6% slope With that same 6'' curb the walkway should be under 8'6'' in length....
- Magnuson Group TERTIO Wall Coat Racks
-
ACCESSIBLE DWELLING UNITS
Requires the Accessibility Specialist plan or above. (Login or upgrade your account!)
-
Technical Memorandum TM 2017-25 Door and Gate Surfaces
This smooth surface must extend the full width of the door or gate....
-
Utilities at Recreation Sites
However, if a condition for exception in an alteration project at an existing site prohibits full compliance with a specific requirement for clear floor or ground space (surface, slope,...
-
Exception 8
When the cost of full compliance with Section 11B-202.4 would exceed 20 percent, compliance shall be provided to the greatest extent possible without exceeding 20 percent....
-
Section 37.151 Waiver for Undue Financial Burden
Generally, the section allows an entity to request a wavier at any time it determines that it will not be able to meet a five-year phase-in or make measured progress toward its full compliance...
-
1016.5 Obstacles
Where possible, obstacles that cross the full width of outdoor recreation access routes should be separated by a distance of 48 inches (1220 mm) minimum....