A. The buildable area is any area of the lot or site where a building can be located in compliance with applicable codes and zoning regulations.
Search Results "Ramp Slope"
Filters
Commonly Searched Documents
-
11.3 Q. The site analysis test calls for a calculation of the percentage of the buildable areas having slopes of less than 10 percent. What is the definition of buildable areas?
-
305.2 Floor or Ground Surfaces
EXCEPTION: Slopes not steeper than 1:48 shall be permitted....
-
305.2 Floor or Ground Surfaces
EXCEPTION: Slopes not steeper than 1:48 shall be permitted....
-
Allen Face F-Meter® Rolling Floor Profiler
The F-Meter® is the finest floor profiling instrument ever made. Pulled manually across the floor, the F-Meter® can measure up to 2500 linear feet (5,000 point elevation readings!)...
-
The Dipstick® Floor Profiler Tool
Advantages The Dipstick Auto-Read Floor Profiler is a totally integrated data collection instrument that provides a fast and accurate method of measuring floors for flatness and...
-
Show us your #CrappyCurb
If a sidewalk doesn't have a Curb Cut which is essentially a small ramp on or off the sidewalk, someone with a mobility disability who uses a cane, wheelchair, motorized scooter, or a walker...
-
11B-305.2 Floor or ground surfaces
Exception: Slopes not steeper than 1:48 shall be permitted...
-
11B-305.2 Floor or ground surfaces
Exception: Slopes not steeper than 1:48 shall be permitted....
-
5.9.2.1 Standing Supports on Single Ramped Entry Raised Platforms with Wheelchair Spaces
5.9.2.1 Standing Supports on Single Ramped Entry Raised Platforms with Wheelchair Spaces....
-
305.2 Floor or Ground Surfaces
[ECTCR UFAS 4.2.4.3] EXCEPTION: Slopes not steeper than 1:48 shall be permitted....
-
305.2 Floor or Ground Surfaces
EXCEPTION: Slopes not steeper than 1:48 shall be permitted....
-
5.9.2.2 Standing Supports on Dual Ramped Entry Raised Platforms with Wheelchair Spaces Recommendations
integrated into the platform and stretching the full length of the platform (40-inch minimum) for dual ramped entry raised platforms....
-
A5
Is a curb ramp provided between the vehicle pull up area and the access aisle (see above) or the access aisle and the accessible route to the accessible entrance?...
-
T302.3 Openings
Ramp and bridgeplate surfaces shall be permitted to have one opening 1½ inches (38 mm) maximum in width and 4½ inches (115 mm) maximum in length to allow the operator to grasp the ramp or...
-
§ 38.125(c)(6)(i) Requirement
When in use for boarding or alighting, the ramp or bridge plate shall be attached to the vehicle, or otherwise prevented from moving such that it is not subject to displacement when loading...
-
DSA IR 11B-3: DETECTABLE WARNINGS AT CURB RAMPS (with revisions issued through Jan. 2011)
General: California Building Code Sections 1127B.5 Item 8 and 1117A.4.7 state “a curb ramp shall have a detectable warning….when the ramp slope is less than 1 unit vertical to 15 units horizontal...
-
T202.1 General
Provision of accessible boarding and alighting shall be made through one or more of the following methods: ramps or bridgeplates complying with T402, lifts complying with T403, or a means...
-
Rockwood Manufacturing Company 700 Handrail Bracket
Material: Cast Brass FASTENER: Wood Rail: 5/16-18 x 1-1/2 FH MS, Lead Anchor; 3 ea. 12-24 x 1 FH MS; 2 ea. #8 x 3/4 OH SMS; 1 ea. Back Plate Metal Rail: 5/16-18 x 1-1/2 FH...
-
Rockwood Manufacturing Company 702 Handrail Bracket
Specifications: Material: Cast Brass FASTENER: Wood Rail: 3 ea. #12 x 2 FH WS; 2 ea. #8 x 3/4 OH SMS Metal Rail: 3 ea. #12 x 2 FH WS; 2 ea. 8-32 x 3/4 OH SMS Ordering: ...
-
1015.2 Where required
Guards shall be located along open-sided walking surfaces, including mezzanines, equipment platforms, aisles, stairs, ramps and landings that are located more than 30 inches (762 mm) measured...
-
1003.3 Clearances
Clearances at boat slips and on boarding piers at boat launch ramps shall comply with 1003.3. Advisory 1003.3 Clearances....
-
1003.3 Clearances
Clearances at boat slips and on boarding piers at boat launch ramps shall comply with 1003.3. Advisory 1003.3 Clearances....
-
505.4 Height
Top of gripping surfaces of handrails shall be 34 inches (865 mm) minimum and 38 inches (965 mm) maximum vertically above walking surfaces, stair nosings, and ramp surfaces....
-
11B-505.4 Height
Top of gripping surfaces of handrails shall be 34 inches (864 mm) minimum and 38 inches (965 mm) maximum vertically above walking surfaces, stair nosings, and ramp surfaces....
