(2) Making curb cuts in sidewalks and entrances;
Search Results "Ramp Slope"
Filters
Commonly Searched Documents
-
§ 36.304(b)(2)
-
Sec.36.304(b)(2)
(2) Making curb cuts in sidewalks and entrances;
-
4.8.4(4)
(4) If a doorway is located at a landing, then the area in front of the doorway shall comply with 4.13.6.
-
505.9 Fittings
Handrails shall not rotate within their fittings.
-
11B-505.9 Fittings
Handrails shall not rotate within their fittings.
-
§ 38.83(c)(6) Attachment
(6) Attachment—
-
11B-505.9 Fittings
Handrails shall not rotate within their fittings.
-
Temporary Suspension
Temporary Suspension In response to business and user concerns about the need for the detectable warnings specified in 4.29 at curb ramps and hazardous vehicular areas, the Access Board...
-
§ 38.125(c)(6)(ii) Exception
Ramps or bridge plates which are attached to, and deployed from, station platforms are permitted in lieu of car devices provided they meet the displacement requirements of paragraph (c)(...
-
Accessible Routes
Accessible boat slips, accessible boarding piers at boat launch ramps,and other accessible spaces and elements within a boating facility must also be connected by an accessible route....
-
EZ-ACCESS Transitions® Modular Entry Mat Video
Requires the Registered User plan or above. Login! -
5.9.2 Standing Supports on Ramped Entry Raised Platforms with Wheelchair Spaces Recommendations
5.9.2 Standing Supports on Ramped Entry Raised Platforms with Wheelchair Spaces Recommendations...
-
R304.5.1.2 Shared Use Paths
In shared use paths, the width of curb ramps runs and blended transitions shall be equal to the width of the shared use path....
-
Non-Circular Cross Sections: ADA Standard Section 505.7.2
Section 505.7.2 covers the current ADA Standards for the non-circular cross section of handrail gripping surfaces.
-
11B-505.7.2 Non-circular cross sections
Handrail gripping surfaces with a non-circular cross section shall have a perimeter dimension of 4 inches (102 mm) minimum and 6¼ inches (159 mm) maximum, and a cross-section...
-
Swimming Pools: ADA Standard Section 242.2
Section 242.2 covers scoping requirements in the current ADA Standards for swimming pools.
-
E. Level Surface
Are the level surfaces of accessible parking spaces and access aisles free of "built-up" curb ramps so persons who use mobility aids (e.g.: wheelchairs, walkers or crutches) can make convenient...
-
1.1.8 Alternate measurement tools
Running slope should be measured along the same lines of measurements as given in Section 1.1.3....
-
1003.3.2 Boarding Pier Clearances
These requirements do not establish a minimum length for accessible boarding piers at boat launch ramps....
-
11B-1003.3.2 Boarding pier clearances
These requirements do not establish a minimum length for accessible boarding piers at boat launch ramps....
-
TEST NO. 2 – SITE ANALYSIS TEST
Calculate the percentage of the total buildable area of the undisturbed site with a natural grade less than 10-percent slope....
-
TEST NO. 2 – SITE ANALYSIS TEST
route to all ground floor units under the following conditions: Calculate the percentage of the total buildable area of the undisturbed site with a natural grade less than 10-percent slope...
-
seca 676 r Digital Wheelchair Scale with Handrail and Integrated RS232 Interface
Two ramps included. Pre-TARE function with three memory cells....
-
Significant alternatives which minimize any significant economic impacts on small entities
Where curb ramps or blended transitions are provided at pedestrian street crossings, detectable warning surfaces indicate the boundary between a pedestrian route and a vehicular route for...
