Accessible route requirements in ADAAG address width (minimum of 36 inches), passing space, head room, surface, slope (maximum of 1:12 or 8.33%), changes in level, doors, egress, and areas...
Search Results "Head End Wall"
-
Accessible Routes
-
1011.7 Outdoor Rinsing Showers
EXCEPTION: Where vandalism is a consideration, a fixed shower head located at 48 inches (1220 mm) above the ground shall be permitted in place of a hand-held shower spray unit....
-
1011.7 Outdoor Rinsing Showers
EXCEPTION: Where vandalism is a consideration, a fixed shower head located at 48 in (1220 mm) above the ground shall be permitted in place of a hand-held shower spray unit....
-
1009.2 Pool Lifts
Additional options such as armrests, head rests, seat belts, and leg support will enhance accessibility and better accommodate people with a wide range of disabilities....
-
§382.143(b)
or more passenger seats, you must provide training meeting the requirements of §382.141(a) for all personnel who deal with the traveling public in connection with flights that begin or end...
-
M304.2.2 Standing Supports
EXCEPTION: Diagnostic equipment with entry and exit permitting pass-through from one end to the other shall be permitted to provide one standing support on one side of the standing surface...
-
§27.1 Purpose.
The purpose of this part is to carry out the intent of section 504 of the Rehabilitation Act of 1973 (29 U.S.C. 794) as amended, to the end that no otherwise qualified individual with a...
-
§104.45(a) Housing provided by the recipient
At the end of the transition period provided for in subpart C, such housing shall be available in sufficient quantity and variety so that the scope of handicapped students' choice of living...
-
R305.2 Placement
Where the back of curb edge is tooled to provide a radius, the border dimension should be measured from the end of the radius....
-
§ 38.113(a)(2)
(2) Doorways at ends of cars connecting two adjacent cars, to the maximum extent practicable in accordance with regulations issued under the Federal Railroad Safety Act of 1970 (49 CFR parts...
-
Kitchens and Kitchenettes
Section 4.34.6 requires a clearance between opposing base cabinets, counters, appliances, or walls of at least 40 inches except in a U-shaped kitchen where the minimum clearance is 60 inches...
-
11B-408.4.6 Car controls
Control panels shall be centered on a side wall....
-
H18
Is the centerline of the toilet 18 inches from the adjacent side wall? [ADA Standards § 4.16.2; 4.17.3] Yes No...
-
M16
Is the centerline of the toilet 18 inches from the adjacent side wall? [ADA Standards §§ 4.16.2; 4.17.3] Yes No...
-
7(1)(b)
(b) Clearance between counters and all opposing base cabinets, countertops, appliances or walls is at least 40 inches....
-
Grab Bar
Grab Bar—A bar attached to a wall to provide a handgrip for steadying oneself or to assist in transferring across short distances....
-
4.18.2 HEIGHT
Urinals shall be stall-type or wall-hung with an elongated rim at a maximum of 17 in (430 mm) above the floor....
-
11B-408.4.6 Car controls
Control panels shall be centered on a side wall....
-
11B-408.4.6 Car controls
Control panels shall be centered on a side wall....
-
704.9 Vertical separation of openings
Openings in exterior walls in adjacent stories shall be separated vertically to protect against fire spread on the exterior of the buildings where the openings are within 5 feet (1524 mm...
-
11B-607.4 Grab bars
Where separate grab bars are required on adjacent walls at a common mounting height, an L-shaped or U-shaped grab bar meeting the dimensional requirements of Section 11B-607.4.1 or 11B-607.4.2...
- Pilot Rock Square Frame Square Table - Series TQ703
-
Handrails
If handrails are mounted on walls, the clear space between the handrail and wall must be 1.5 inches....