[See subsections ...]
Search Results "Seat Location"
-
DIVISION 9: BUILT-IN ELEMENTS
-
CHAPTER 9: BUILT-IN ELEMENTS
CHAPTER 9: BUILT-IN ELEMENTS
-
M303.2.2 Width
EXCEPTION: Wheelchair spaces located on raised platforms shall be permitted to be 32 inches (815 mm) wide minimum to a height of 4 inches (100 mm) measured from the platform surface....
-
M303.2.2 Width (Section-by-Section Analysis)
The MDE NPRM proposed to require that diagnostic equipment used by patients seated in a wheelchair provide a wheelchair space that was at least 36 inches wide....
-
Wheelchair accessible seating is required. At least one percent of the seating must be wheelchair seating locations.
• Wheelchair accessible seating is required. At least one percent of the seating must be wheelchair seating locations....
-
5.8.3 Breast Platform Recommendations
5.8.2 Knee and Toe Clearance Recommendations under Breast Platforms), the height of the breast platform is also critical to ensuring that mammography equipment is accessible to patients seated...
-
Methodology
This study was approved by the University of Pittsburgh's Institutional Review Board and all participants provided informed consent before participating in any test procedures.
-
§ 35.138(d) Notification of accessible seating locations
(d) Notification of accessible seating locations. ...
-
Transfer Protocols
Two participants (P2 and P3) did not attempt to transfer higher or lower than their mobility seat for different reasons. ...
-
Transfer Heights
For instance, level seat heights were 21.7± 1.2 inches and 22.1±1.4 inches for the first and second phases respectively....
-
American Standard Madera 1.6 gpf ADA Toilet with Exposed Manual Flush Valve System
Elongated floor mount flushometer valve toilet, top and back spud, less seat High Effeciency, low consumption 1.6 GPF Conventional glazed Fully glazed 2-1/8” trapway...
-
American Standard Madera 1.28 gpf ADA Toilet with Exposed Manual Flush Valve System
Elongated floor mount flushometer valve toilet, top and back spud, less seat High Effeciency, low consumption 1.28 GPF Conventional glazed Fully glazed 2-1/8” trapway...
-
Section 36.406(f) Assembly Areas (Section-by-Section Analysis)
The NPRM proposed at Sec. 36.406(f)(1) to require wheelchair spaces and companion seating locations to be dispersed to all levels of the facility that are served by an accessible route....
-
M305.2.1 Location (Section-by-Section Analysis)
, and requiring the transfer support to be located on the side of the transfer surface opposite the transfer side....
-
4.35.4 Bench
Where installed in conjunction with showers, swimming pools, or other wet locations, water shall not accumulate upon the surface of the bench and the bench shall have a slip-resistant surface...
-
11B-216.2 Designations
Exception: Exterior signs that are not located at the door to the space they serve shall not be required to comply with Section 11B-703.2....
-
11B-609.4 Position of grab bars
Grab bars shall be installed in a horizontal position, 33 inches (838 mm) minimum and 36 inches (914 mm) maximum above the finish floor measured to the top of the gripping surface,...
-
609.4 Position of Grab Bars
Grab bars shall be installed in a horizontal position, 33 inches (840 mm) minimum and 36 inches (915 mm) maximum above the finish floor measured to the top of the gripping surface,...
-
3.4.6 Surface
The surface of each viewing area shall be firm and stable. The type of surface should be appropriate to the setting and level of development.
-
609.4 Position of Grab Bars
Grab bars shall be installed in a horizontal position, 33 inches (840 mm) minimum and 36 inches (915 mm) maximum above the finish floor measured to the top of the gripping surface,...
-
Required Number [§208]
Required Number [§208] This guide explains requirements in the ADA Standards for parking. Accessible parking spaces are required for each parking facility on a site, such as...
-
11B-609.4 Position of grab bars
11B-609.4 Position of grab bars. Grab bars shall be installed in a horizontal position, 33 inches (838 mm) minimum and 36 inches (914 mm) maximum above the finish floor measured to...
-
11B-609.4 Position of grab bars
Grab bars shall be installed in a horizontal position, 33 inches (838 mm) minimum and 36 inches (914 mm) maximum above the finish floor measured to the top of the gripping surface,...
