5.4.3.1 Positioning Support Height for Imaging Equipment. Positioning supports should be positioned 3 to 6 inches above the transfer surface....
Search Results "Adjustable Height Counter"
Filters
Commonly Searched Documents
-
5.4.3.1 Positioning Support Height for Imaging Equipment
-
11B-809.10.7.4 Seat height
Water closet seats shall be 15 inches (381 mm) minimum and 19 inches (483 mm) maximum measured to the top of the seat above the finish floor.
-
4.4 Knee and Toe Clearances
Center- adjusted data removed due to foot position of one subject (dotted line) Figure 27....
-
Caroma® USA Somerton Smart 270 Easy Height Elongated Toilet
A modern concept close coupled 1.28/0.8 gpf (4.8/3 lpf), Somerton Smart 270 Easy Height Elongated dual flush washdown toilet installation designed to provide a seat height of between 17”...
-
5.8.2.1 Height of Breast Platform At Time of Measurement
5.8.2.1 Height of Breast Platform At Time of Measurement. All knee and toe clearances should be measured when the top of the breast platform is set at 34 inches above the floor....
-
BENEFITS AND COSTS: SUMMARY
BENEFITS AND COSTS: SUMMARY Therefore, while establishing these requirements will result in significant costs to health care providers, establishing a lower adjustable height requirement...
-
San Jamar C3000EWH-PSS Adjustable Portion Cup Dispenser
Our Adjustable Portion Cup Dispensers are designed to provide easy and efficient one-at-a-time cup dispensing....
-
2.4.1 Current Marketplace Dynamics
are height-adjustable (Figure 2.4.1(b))....
-
Re: Service Counters
Also, an employee may also need the lower counter. For these reasons, I would advise against using it....
-
Mayer-Rothschild Foundation: Determination of Grab Bar Specifications for Independent and Assisted Transfers in Residential Care Settings
The purpose of this project is to identify, both objectively and subjectively, the spatial and configurational dimensions of grab-bars that effectively support both independent...
-
407.12 Reach Height (Section-by-Section Analysis)
407.12 Reach Height (Section-by-Section Analysis) This section proposes requirements for the height of side and forward reaches that would enable persons using wheelchairs or other mobility...
-
407.8.3.2.1 Operable Part Height for ICT with Obstructed Forward Reach
The height of the operable part shall conform to Table 407.8.3.2.1....
-
1136A.1 Receptacle heights
Baseboard electrical outlets used in relocatable partitions, window walls or other electrical convenience floor outlets are not subject to the minimum height requirements....
-
5.8.1.2.4 Edge Protection on Platforms 1½ inches or less in Height
5.8.1.2.4 Edge Protection on Platforms 1½ inches or less in Height. Edge protection is not required on platforms 1 ½ inches or less in height....
-
2101KG HR Digital Platform Scale with Mechanical Height Rod
The “live” handrails allow the patient to hold on for stability while the scale accurately calculates weight and height....
-
1136A.1 Receptacle heights
Baseboard electrical outlets used in relocatable partitions, window walls or other electrical convenience floor outlets are not subject to the minimum height requirements. 4....
-
SECTION 1136A ELECTRICAL RECEPTACLE, SWITCH AND CONTROL HEIGHTS
SECTION 1136A ELECTRICAL RECEPTACLE, SWITCH AND CONTROL HEIGHTS...
-
2101KL HR Digital Platform Scale with Mechanical Height Rod
The “live” handrails allow the patient to hold on for stability while the scale accurately calculates weight and height....
-
5.8.2.6 Clearance Depth at Toe Height above the ground Recommendation
5.8.2.6 Clearance Depth at Toe Height above the ground Recommendation The Committee recommends 22 inches minimum clearance depth at toe height....
-
5.8.1.2.4 Edge Protection on Platforms 1½ inches or less in Height Recommendations
5.8.1.2.4 Edge Protection on Platforms 1½ inches or less in Height Recommendations The Committee recommends that no edge protection be required on platforms of 1½ inches or less in height...
-
American Specialties Circular Counter Top Waste Chute Model 1000
Requires the Premium User plan or above. (Login or upgrade your account!) -
Mammography Equipment
The mammography machine will need to adjust to their height and accommodate the space of the wheelchair....
-
M305.3.2 Height (Section-by-Section Analysis)
For horizontal supports, the MDE NPRM proposed a gripping surface height of 34 inches minimum and 38 inches maximum above the standing surface....
