The angle of the water stream shall be measured horizontally relative to the front face of the unit....
Search Results "Horizontal Exit"
Filters
Commonly Searched Documents
-
602.6 Water Flow
-
Transfer Supports Location and Configuration M301.3 and M302.3
The shape (contours and curves along length for ergonomics, not cross sectional profile) was kept open to give manufacture flexibility in the design as the direction of positioning (i.e. horizontal...
-
1002.4.3 Gaps
coordinated so that, when amusement rides are at rest in the load and unload position, the vertical difference between the floors shall be within plus or minus 5/8 inches (16 mm) and the horizontal...
-
Water closet
In the horizontal or down position, grab bars on both sides of the toilet would permit individuals requiring assistance to maintain balance while clothing was removed or replaced....
-
Slope [§405.2] and Cross Slope [§405.3]
Slope [§405.2] and Cross Slope [§405.3] Slope represents the proportion of vertical rise to horizontal length and is specified in the Standards as a ratio (e.g., 1:12)....
-
11B-1002.4.3 Gaps
coordinated so that, when amusement rides are at rest in the load and unload position, the vertical difference between the floors shall be within plus or minus 5/8 inches (15.9 mm) and the horizontal...
-
11B-1002.4.3 Gaps
coordinated so that, when amusement rides are at rest in the load and unload position, the vertical difference between the floors shall be within plus or minus 5/8 inches (15.9 mm) and the horizontal...
-
Seating Accommodations
The apparent rationale for this request was to make it more convenient for such passengers to access their personal wheelchairs quickly in order to transfer to another flight or exit the...
-
11B-608.6 Shower spray unit and water
Each shower head shall be installed so it can be operated independently of the other and shall have swivel angle adjustments, both vertically and horizontally....
-
Proline Drain: Quick Drain USA - Side Waste Outlet Tub to Shower Conversion
When completing a tub to shower conversion where there is no vertical penetration between the floors, and only a horizontal penetration to the plumbing wall, a side waste outlet is necessary...
-
Landscape Forms Inc. MultipliCITY Bike Rack
A horizontal bar between the top and bottom of the frame offers a place to affix a bike cable and keeps the bike lock from falling to the ground....
-
Hollaender ADA Handrail Systems: Grabrail (ADA Rail)
An ADA rail is the framework of (usually) two horizontal rails supported by vertical posts, manufactured from fittings and pipe....
-
M-D Building Products, Inc. GEN2 SmartTool™ Digital Level
reference Directional beep engages if activated Eliminates math when adding or subtracting from an angle Use for bending pipe, setting rafters, relative angle changes Glowing horizontal...
-
1010.1.9.7 Delayed egress locks
An attempt to egress shall initiate an irreversible process that shall allow such egress in not more than 15 seconds when a physical effort to exit is applied to the egress side door hardware...
-
1134A.4 Sufficient maneuvering space
required to be adaptable shall provide sufficient maneuvering space for a person using a wheelchair or other mobility aid to enter and close the door, use the fixtures, reopen the door and exit...
-
New Provisions for Employee Work Areas
The proposed rule required such areas to be on an accessible route so that people with disabilities could approach, enter, and exit the space....
-
1133B.2.5.1
SECTION 1133B GENERAL ACCESSIBILITY FOR ENTRANCES, EXITS AND PATHS OF TRAVEL 1133B.2 Doors. 1133B.2.5.1 Door closer. ...
-
Accessible Routes
The accessible route must connect all entry and exit points of accessible play components. ...
-
The September 11, 2001 Wake-up Call
We need to be proactive, and rely as much as possible on ourselves (and not to count on others), to find the exits and to make decisions about our safety....
-
Clear Floor Space [4.35.2]
Space is important so that users can turn around and exit through swinging or sliding doors. Benches can overlap turning space where clearance (9 inches minimum) is available for toes....
-
Employee Work Areas [§206.2.8]
However, these types of employee work areas still must be accessible for “approach, entry, and exit” (§203.9)....
-
M301.3 Transfer Supports
Height: Located no less than 6 inches (150 mm) and no more than 19 inches (482 mm) above the patient support surface Horizontal Distance from Transfer Surface: No more than 3 inches (...
-
602.6 Water Flow
The angle of the water stream shall be measured horizontally relative to the front face of the unit....
-
1127B.5, Item 4
each curb ramp over its full width to permit safe egress from the ramp surface, or the slope of the fanned or flared sides of the curb ramp shall not exceed one unit vertical in 12 units horizontal...
