The detectable warning shall extend the full width of the curb ramp (exclusive of flared sides) and shall extend either the full depth of the curb ramp or 24 inches (610 mm) deep minimum measured...
Search Results "Mitigating Measures"
-
11B-406.5.12 Detectable warnings
- Beneficial Designs High Efficiency Trail Assessment Process (HETAP) Software 3.0 Wheeled Instrumentation Sensor Package for Data Collection
-
Back Support
The Board has added clarification that the back support may be located up to 2 ½ inches from the rear edge of the seat, measured horizontally....
-
11B-809.10.6.1 Size
least one shower stall shall comply with one of the following: A transfer type shower compartment 36 inches (914 mm) wide by 36 inches (914 mm) deep, clear inside dimensions measured...
-
11B-404.2.10 Door and gate surfaces
Swinging door and gate surfaces within 10 inches (254 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...
-
Door and Gate Surfaces: ADA Standard Section 404.2.10
Section 404.2.10 covers the current ADA Standards for door and gate surfaces on manual doors and gates.
-
11B-404.2.10 Door and gate surfaces
Swinging door and gate surfaces within 10 inches (254 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...
-
Toto Site Review: A Criteria-Based Evaluation Framework
Security measures also matter. Multi-layer authentication, encrypted data handling, and anomaly detection systems indicate higher operational maturity....
-
Safe harbor.
As a result of this flexibility, the Department believes that the program accessibility requirement as it is codified in the current regulation may appropriately mitigate any burdens on...
-
Executive Order 13132: Federalism
The 2010 Standards address federalism concerns and mitigate federalism implications, particularly the provisions that streamline the administrative process for State and local governments...
-
III-3.8000 Direct threat
duration, and severity of the risk; 2) The probability that the potential injury will actually occur; and 3) Whether reasonable modifications of policies, practices, or procedures will mitigate...
-
H.2. - Does Section 508 apply to a Federal agency's existing EIT procured prior to June 21, 2001?
Although the amendments to Section 508 were effective on August 7, 1998, there were no standards to measure compliance until the standards published by the Access Board became effective...
-
Surcharges
against discrimination: (f) A public entity may not place a surcharge on a particular individual with a disability or any group of individuals with disabilities to cover the costs of measures...
-
308.3.1 Unobstructed
Operable parts of fuel dispensers shall be permitted to be 54 inches (1370 mm) maximum measured from the surface of the vehicular way where fuel dispensers are installed on existing curbs...
-
308.3.1 Unobstructed
Operable parts of fuel dispensers shall be permitted to be 54 inches (1370 mm) maximum measured from the surface of the vehicular way where fuel dispensers are installed on existing curbs...
-
604.3.2 Overlap
complying with 606 shall be permitted on the rear wall 18 inches (455 mm) minimum from the water closet centerline where the clearance at the water closet is 66 inches (1675 mm) minimum measured...
-
FAQ: How do I upgrade my subscription?
Upgrading to a Premium or Accessibility Specialist level subscription will provide access to more Corada content such as selected state accessibility requirements, "how to measure" videos...
-
[F] 907.4.2.2 Height
The height of the manual fire alarm boxes shall be not less than 42 inches (1067 mm) and not more than 48 inches (1219 mm) measured vertically, from the floor level to the highest point...
-
11B-308.3.1 Unobstructed
Operable parts of fuel dispensers shall be permitted to be 54 inches (1372 mm) maximum measured from the surface of the vehicular way where fuel dispensers are installed on existing curbs...
-
1132A.5.1 General
Maneuvering clearances at interior doors shall provide a minimum length on both sides of the door of at least 42 inches (1067 mm) measured at a right angle to the plane of the door in its...
-
1132A.5.1 General
Maneuvering clearances at interior doors shall provide a minimum length on both sides of the door of at least 42 inches (1067 mm) measured at a right angle to the plane of the door in its...
-
[F] 907.4.2.2 Height
The height of the manual fire alarm boxes shall be not less than 42 inches (1067 mm) and not more than 48 inches (1219 mm) measured vertically, from the floor level to the highest point...
-
308.3.1 Unobstructed
Operable parts of fuel dispensers shall be permitted to be 54 inches (1370 mm) maximum measured from the surface of the vehicular way where fuel dispensers are installed on existing curbs...
-
903.4 Back Support
Back support shall be 2 1/2 inches (64 mm) maximum from the rear edge of the seat measured horizontally. Advisory 903.4 Back Support....